Sharp GX-CD1200W BK, Operation Manual

E-11

PLAY

PLAY

RECORD

DUBBING 

SPEED

FUNCTION

VOLUME

MIX MIC

,

,

PLAY/PAUSE

USING EXTERNAL UNITS

PHONES

■

 Mixing from a microphone and TAPE

To listen to or record mixed signals from an external mi-
crophone and TAPE.

1

To protect the speakers from shock noise and to avoid dis-
turbing noises, set the VOLUME control to minimum.

●

Be sure that the microphone has a 3.5 mm (1/8") diameter
plug, and is of 600 ohms impedance; if not, use an appro-
priate adaptor.

2

Connect the microphone plug to the MIX MIC socket.

3

Set the FUNCTION switch to TAPE.

4

Load a cassette into the TAPE 1 or TAPE 2 cassette com-
partment.

5

Press the PLAY button of the TAPE 1 or TAPE 2.

6

Adjust the volume of the audio source and the microphone
using the VOLUME control.

For mixing recording

1

Perform steps 1 - 3 above.

2

Load a blank tape into the TAPE 1 cassette compartment.
Insert a prerecorded cassette into the TAPE 2 cassette
compartment.

3

Set the DUBBING SPEED switch to NORMAL.

●

Mixing recording is not possible if the DUBBING SPEED
switch is set to HIGH.

4

Press the RECORD button of TAPE 1.

5

Press the PLAY button of TAPE 2.

Notes:

●

Place the microphone about 10-15 cm (4-6") away from
the source.

●

If howling occurs, lower the volume or move the microphone
as far as possible from the speakers.

●

To record the microphone signals only, load a cassette into
the TAPE 1 cassette compartment, set the FUNCTION
switch to TAPE and the DUBBING SPEED switch to NOR-
MAL. Then, press the RECORD button.

Caution:

●

When not using the microphone, remove the microphone
plug from the MIX MIC socket.

■

 Mixing from a microphone and a CD

To listen to or record mixed signals from an external mi-
crophone and CD.

1

To protect the speakers from shock noise and to avoid dis-
turbing noises, set the VOLUME control to minimum.

●

Be sure that the microphone has a 3.5 mm (1/8") diameter

plug, and is of 600 ohms impedance; if not, use an appro-
priate adaptor.

2

Connect the microphone plug to the MIX MIC socket.

3

Set the FUNCTION switch to CD.

4

Load a compact disc into the CD compartment.

5

Press the PLAY/PAUSE button on the CD.

6

Adjust the volume of the audio source and the microphone
using the VOLUME control.

For mixing recording

1

Perform steps 1 - 4 above.

2

Load a blank tape into the TAPE 1 cassette compartment.

3

Set the DUBBING SPEED switch to NORMAL.

●

Mixing recording is not possible if the DUBBING SPEED

switch is set to HIGH.

4

Press the RECORD button of TAPE 1.

5

Press the PLAY/PAUSE button on the CD.

■

 Headphones

●

Before plugging in or unplugging the headphones, make

sure the volume level is reduced.

●

Be sure your headphones have a 3.5 mm (1/8") diameter

plug and are between 16 ohms and 50 ohms impedance.
The recommended impedance is 32 ohms.

●

Connect the headphones plug to the PHONES socket. The

speakers will be automatically disconnected. Adjust the
volume by using the VOLUME control.