Call Functions
19
Redialling
You can redial numbers in the call log. Select from
specific categories or “All Calls”. Specific category
contains up to 10 numbers and the “All Calls” list
contains up to 30.
1.
Press
D
during standby .
2.
Select the category from “All Calls”, “Dialled
Nos.”, “Missed Calls”, or “Received Calls”.
To switch logs, press
c
or
d
.
3.
Select the phone number you wish to call.
4.
Press
D
to redial the call.
Automatic Redialling
This setting allows you to automatically redial the
number if the first attempt was unsuccessful because
the called party was busy.
If you wish to stop redialling, press
F
or [End].
To Set the Auto Redial Function
“Settings”
→
“Call Settings”
→
“Auto Redial”
1.
Select “On” or “Off”.
Note
• When you receive an incoming call, the Auto Redial
function is interrupted.
• Automatic redialling is not available for fax and data
calls.
Answering a Call
When an incoming call is detected, the phone rings.
1.
Press
D
,
or [Answer] to answer the call.
Or press any key except
F
and [Busy] when the
“Any Key Answer” function is enabled. Set the Any
Key Answer function in the profile of each mode.
(p. 91)
Tip
• When the Personal Handsfree Kit (option) is
connected to the phone, you can answer calls by
pressing the Answer button.
• If you have subscribed to the Calling Line
Identification (CLI) service and the caller’s network
sends the number, the caller’s number is displayed on
the screen. If the caller’s name and number are
stored in the Phonebook, the caller’s name and
phone number are displayed on the screen.
• If the number is a restricted number, the display
shows “Withheld”.
• When receiving a call from the person whose picture
is registered in the Phonebook, receiving display and
the picture are displayed alternately.
Summary of Contents for GX-T17
Page 1: ......