Settings 107
•
The passcode is used only once, so there is no need to
remember it. The passcode can be different each time
the devices are connected.
•
Devices that do not have a user interface (i.e.,
headsets and car kits) have a factory-set passcode.
See the user guide for the device.
•
If the Bluetooth wireless function is off before
searching, the phone turns the Bluetooth wireless
function on automatically and starts searching.
•
When you wish to perform the device search again,
the device list where all devices searched will be
displayed when selecting “Search for Devices”
again in step 1. Highlighting “New Devices” at the
top of the list and pressing
e
will resume the new
search and refresh the list.
•
You can only select one device for pairing. To change
the paired device, see “Paired Devices”.
Paired Devices
You can activate, rename, and delete the paired device
in the list.
To Activate a Device
“Settings”
→
“Connectivity”
→
“Bluetooth”
→
“Paired Devices”
1.
Select the device you wish to activate.
Tip
•
You can save battery power by turning the Bluetooth
wireless function off while it is not in use. Turn the
Bluetooth wireless function off in “To Turn On or
Off” on page 106.
•
During a call, you can divert voice call to the paired
device. Press [Options] and select “Enable
Bluetooth”. If you wish to disconnect the paired
device, select “Disable Bluetooth”.
To Rename a Device
“Settings”
→
“Connectivity”
→
“Bluetooth”
→
“Paired Devices”
1.
Highlight the device you wish to rename.
2.
Press [Options] and select “Change Name”.
3.
Rename the device.
To Clear a Device Name
“Settings”
→
“Connectivity”
→
“Bluetooth”
→
“Paired Devices”
1.
Highlight the device you wish to clear.
2.
Press [Options] and select “Delete”.
