35
HT-CN300W_A_5.fm
02/7/11
HT-CN300W
Re
fe
re
nces
- T
roub
leshooting c
h
ar
t /
E
rr
o
r
indicator
s a
n
d
w
a
rn
ings /
Mai
n
tena
n
ce -
Troubleshooting chart (continued)
„
TV image
„
If trouble occurs
When this product is subjected to strong external interference (mechanical shock,
excessive static electricity, abnormal supply voltage due to lightning, etc.) or if it is
operated incorrectly, it may malfunction.
If such a problem occurs, do the following:
Clearing all the memory (reset): Main unit
Caution:
This operation will erase all data stored in memory and restore various settings to the
initial status (default).
Clearing all the memory (initialisation): Remote control
Refer to "Initialising the remote control buttons" on page 21 for details.
Caution:
This operation will reset all data stored in memory to the initial status (default).
Error indicators and warnings
When you load an unplayable disc or fail to perform operations properly, the following
messages are displayed on the unit and the TV screen.
Maintenance
„
Cleaning the cabinet
Periodically wipe the cabinet with a soft cloth and a diluted soap solution, then with a
dry cloth.
z
Do not use chemicals for cleaning (petrol, paint thinner, etc.). It may damage the
cabinet finish.
z
Do not apply oil to the inside of the unit. It may cause malfunctions.
Symptom
Possible cause
Reference
page
No images are displayed.
z
Is TV turned on?
P. 18
z
Is the input of TV switched?
P. 18
z
Is TV connected properly?
P. 10
Settings are not displayed on
the TV screen.
z
The settings will not appear when
TV is connected with an S-video
cable. Verify on the main unit
display.
P. 23
Interference or noise occurs
on the TV image.
z
Is the unit placed near TV with
internal aerial? Use an external
aerial.
Colour variation interference
shows on the TV image.
z
Are the speakers placed in their
proper distances? Turn off the TV
and turn it back on after 15 - 30
minutes. If the situation persists,
move the speakers further away
from the TV.
P. 14
1 Unplug the unit.
2 Whilst holding down the ON/STAND-BY button, plug in the AC
power lead.
Release the ON/STAND-BY button when the "CLEAR AL" is
displayed.
3 Press the ON/STAND-BY button again to turn the power on.
Display
Meaning
z
The surround system does not operate properly.
z
Place the unit away from noise source or plug the
AC power lead to another AC socket. (*)
z
The amplifier is defective or the surround system
does not operate properly.
z
Place the unit away from noise source or plug the
AC power lead to another AC socket. (*)
(*): Should the same message appear even if the unit is unplugged and plugged in or
is set to the stand-by mode and on again, contact your local dealer where you
purchased the unit.
Summary of Contents for HT-CN300W
Page 38: ...MEMO ...
Page 39: ...MEMO ...
