E-12
Remote control
General control
■
Battery installation
1
Open the battery cover.
2
Insert the batteries according to the terminal
indicated in the battery compartment. When
inserting or removing the batteries, push them
toward the (–) battery terminals.
3
Close the cover.
Caution:
●
Replace all old batteries with new ones at the
same time.
●
Do not mix old and new batteries.
●
Remove the batteries if the unit will not be used
for a long period of time. This will prevent poten-
tial damage due to battery leakage.
●
Do not use rechargeable batteries (nickel-cad-
mium battery, etc.).
●
Installing the batteries incorrectly may cause the
unit to malfunction.
●
Batteries (battery pack or batteries installed)
shall not be exposed to excessive heat such as
sunshine, fire or the like.
Notes concerning use:
●
Replace the batteries if the operating distance
is reduced or if the operation becomes erratic.
Purchase 2 “AAA” size batteries (UM/SUM-4,
R3, HP-16 or similar).
●
Periodically clean the transmitter on the remote
control and the sensor on the unit with a soft
cloth.
●
Exposing the sensor on the unit to strong light
may interfere with operation. Change the light-
ing or the direction of the unit.
●
Keep the remote control away from moisture,
heat, shock, and vibrations.
■
Test of the remote control
The remote control can be used within the range
shown below:
0.2 m - 6 m
Remote sensor
■
To turn the power on
When you first connect the sound bar and the sub-
woofer to the main socket, it will be in STANDBY
mode.
The LED indicator will light up red.
●
Press the button on the sound bar or remote
control to switch the sound bar ON or OFF.
●
Disconnect the main plug from the main socket
if you want to switch off the sound bar and sub-
woofer completely.
Notes:
The system will automatically power on if TV or
similar component which supports HDMI CEC, is
turned on.
■
To set the sound bar to standby mode
●
During stand by mode, the sound bar will auto-
matically power on if it detects audio signal from
HDMI/ARC, OPTICAL connection that has been
set up between the sound bar and your device.
●
When the sound bar has no input signal for over
15 minutes, it will automatically switch to Stand-
by mode.
\
■
Eco mode
●
The first time the unit is plugged in it will enter
standby mode (Eco mode off). Sound bar indi-
cator turns red.
●
To cancel the standby mode, perform the follow-
ing procedure.
During standby mode, press and hold the button
for 6 seconds
- Sound bar indication light turned off.
Notes:
●
When turning on the power from Eco mode, it
may take some time until the power is turned on.
Caution:
●
During Eco mode, very small power is con-
sumed when the power cord is connected.
To cancel the Eco mode:
When the sound bar is turned off, press and hold
the POWER button for 6 seconds.
- Sound bar indication lights up in red.
