1
IMPORTANT SAFETY INSTRUCTIONS
SAVE THESE INSTRUCTIONS
This manual contains important safety instructions that shall be followed during the installation and maintenance of the
solar power inverter.
To reduce the risk of electrical shock, and to ensure the safe installation and operation of the solar power inverter, the
following words appear throughout this manual to inform you of or alert you to something that may cause a dangerous
situation or that safety instructions must be followed.
Conventions Used
The following conventions are used in this guide.
General Safety Precautions for Installation
May cause serious injury or death unless the instructions are followed.
May injure a person or damage equipment unless the instructions are followed.
Important information to be followed when installing or using the solar power inverter.
• This solar power inverter must be installed by a licensed electrical contractor in accordance with:
a) AS/NZS 5033 Installation of photovoltaic (PV) arrays
b) AS/NZS 3000 Electrical Installations (know as the Australian/ New Zealand Wiring Rules
c) Applicable local electrical service rules.
• Installation by a non licensed person is against the law, and could cause electric shock or severe injury if installed incorrectly.
Additionally, your insurance policies and manufacturers warranty will become void and the manufacturer will not liable for any
claims.
• Correct installation will assist the maximum amount of electricity to be exported to the grid.
• To avoid electric shock or burns, always follow all warnings and cautions marked on the solar power inverter, and in this manual.
• Ensure that all electrical connections are secure, loose connections can cause overheating, smoke and fire.
• This solar power inverter is a grid connect device only, it is not intended for stand alone operation.
• Ensure that the AC and DC isolation is switched off before connecting/ disconnecting the inverter.
• The surface of the inverter case can become hot during normal operation. In extreme conditions, the inverter chassis can reach
temperatures of up to 70
°
C. To avoid accidental burns;
ensure that the inverter is not within reach of children.
do not install it in a location where people can accidentally come into contact with the unit.
• Install the unit according to the installation instructions paying particular attention to clearances for free air circulation. Installing
this device in improper locations may cause overheating, smoke and fire.
• Do not cover or impede the free air flow around the unit, this may cause overheating and reduced performance.
• Do not disassemble or attempt to repair the unit, disassembling the unit will break the seal and void the manufacturer's warranty.
• Do not install the unit on an external wall near the ocean, salt air can cause corrosion.
• The inverter does not contain DC or AC isolation switches, these should be provided by the installer.
