9
·
38
9
Select system of each channel in SEND/RECEIVE function
[3] Setting procedure
In brackets: See page in chapter 9
Start slave station PC operation
Turn ON the power of master station PC
[ 39 ]
Connect support tools
[ 39 ]
Stop PC operation
[ 39 ]
[ 39 ]
Stop operation of data link (007777
(8)
=00
(H)
)
[ 39 ]
Set top address of the relay link area on the master station
[ 40 ]
Set data link function (004002
(8)
=01
(H)
)
[ 42 ]
Set number of connecting stations
[ 42 ]
①
②
③
[ 42 ]
Set top address of register link area on master stations
[ 43 ]
⑤
Set top address of register link area on slave station 01 to 77
(8)
(at standard function)
/number of off set bytes (at memory capacity save function)
⑥
[ 44 ]
Set time-out time of SEND/RECEIVE instruction
Set number of sending bytes of the master station relay link
[ 45 ]
Set number of sending bytes of the slave station 01 to 77
(8)
relay link
[ 45 ]
Set number of sending bytes of the master station register link
[ 46 ]
[ 46 ]
[ 47 ]
[ 48 ]
[ 49 ]
⑦
⑧
⑨
⑩
⑪
⑫
⑬
Set number of sending bytes of the slave station 01 to 77
(8)
register link
⑭
[ 50 ]
④
Whether the station number information should be output or not
Set connection status of slave stations
[ 50 ]
[ 50 ]
Set top address of flag area
[ 51 ]
[ 51 ]
PC operation
[ 52 ]
End
⑮
⑯
⑰
⑱
①
to
⑲
correspond to numbers in page 9·33.
Top address in communication information storage area
when using data memory starting system of SEND/RECEIVE functions
Set top address of relay link area on slave station 01 to 77
(8)
(at standard function)
/number of offset bytes (at memory capacity save function)
When not using
SEND/RECEIVE function
Set PC model of each station
Writing to EEPROM, start operation (007777
(8)
=81
(H)
)
[ 52 ]
⑲
V5
V5
V5
Set detection time of communication error
