30
KB-6014LS
KB-6014LK
KB-6014LW
1. Follow the Microwave Drawer disassembly as previously
stated
.
Open the drawer and keep it open.
3. To discharge the high voltage capacitor, wait for 60
seconds.
4. Remove the both right and left side panels.
5. Remove () Drawer Support Covers from Choke Cover as
shown in
(Fig. D-1)
.
6. Insert a putty knife (thickness of about 0.5mm) into the gap
between the choke cover and the door frame.
7. Carefully slide choke cover away from drawer as far as
possible.
8. Remove (6) screws from all (3) drawer Support Angles as
shown in
(Fig. D-2)
.
9. Unhook Drawer Support Angles from drawer, then
remove.
10. Now, the door assembly is free and the Choke Cover can
now be removed.
DRAWER SUPPORT ANGLE REMOVAL
1. Remove Drawer Assembly and Choke Cover as stated in
"DRAWER ASSEMBLY AND CHOKE REMOVAL".
. Remove () screws from right or left Latch Angle Assembly,
then remove Angle assembly
(Fig. D-4)
.
3. Separate Slide Rails by moving inside lever of Slide Rails.
The Slide Rail will now separate by pulling straight forward
and out
(Fig. D-3)
.
4. At this point, you can replace either Latch Angle Assy or
Latch Angles.
To reassemble, just reverse the above order.
After reassembly, do the following.
(A) Make sure that drawer sensing switch, secondary
interlock switch and monitor switch are operating
properly. (Refer to chapter "Test Procedures".)
(B) An approved microwave survey meter should be used
to assure compliance with proper microwave radiation
emission limitation standards.
After any servicing, make sure of the following :
1. Drawer latch heads smoothly catch latch hook through
latch holes and that latch head goes through center of latch
hole.
. Deviation of door alignment from horizontal line of cavity
face plate is to be less than 1.0mm.
3. Drawer is positioned with its face pressed toward cavity face
plate.
4.
Reassemble the unit
and check for microwave leakage around
drawer with an approved microwave survey meter. (Refer
to Microwave Measurement Procedure.)
Note: The drawer on a microwave oven is designed to
act as an electronic seal preventing the leakage of
microwave energy from oven cavity during cook
cycle. This function does not require that door be
air-tight, moisture (condensation)-tight or light-tight.
Therefore, occasional appearance of moisture, light
or sensing of gentle warm air movement around oven
drawer is not abnormal and do not of themselves
DRAWER/SLIDE RAIL REMOVAL
DRAWER ASSEMBLY AND CHOKE REMOVAL
Fig. D-1
Fig. D-2
Fig. D-3
Fig. D-4
NOTE:
To remove only the
Microwave Drawer, follow steps
1, , 5, 8, 9 & 10
as instructed under
"DRAWER ASSEMBLY AND
CHOKE REMOVAL".
