E-11
1. Remove the Back Panel.
2. Remove the sensor filter.
3. If the sensor filter is very dirty, wash
it with water and dry it thoroughly.
1. Add a small amount of kitchen
detergent to water and soak for
about 10 minutes.
2. Rinse off the kitchen detergent with
clean water.
3. Completely dry the filter in a
wellventilated area.
Clean the inside of
the Water Tank with
a soft sponge and
the Tank Cap with
a cotton swab or
toothbrush.
CARE AND MAINTENANCE
1
4
2
3
5
2
Place
Ref.
1
Water Tank
E-11
2
Unit / Back Panel (Pre Filter)
3
Sensors
4
Humidifying Filter
E-12
Humidifying Tray
5
HEPA Filter
E-13
Deodorizing Filter
The filter reset Indicator light will turn on after approximately
720 hours operating. (30 days × 24 hours =720 hours)
This is a reminder to perform the maintenance described
below. After performing maintenance, reset the Filter
Indicator.
Do not apply excessive pressure
when scrubbing the back panel.
RESET
Rinse the inside
with water.
Wipe with a dry, soft cloth.
Remove the dust gently with
a cleaning tool such as a
vacuum cleaner.
NOTE
NOTE
How to clean hard to remove dirt.
How to clean hard to remove dirt.
Tank Cap
Toothbrush
Sensors
Back Panel
(Pre Filter)
Sensor Filter
CAUTION
Back Panel
Sensor Filter
FILTER INDICATOR
CARE INDEX
WATER TANK
UNIT / BACK PANEL
more
3 sec.
