EN - 24
9. AUTOMATIC FAULT WARNINGS AND WHAT TO DO
Your tumble dryer is equipped with a built-in fault detection system, indicated by a
combination of flashing operation lights. The most common failure codes are shown below.
ERROR CODE
SOLUTION
E03 /
Empty the water tank, if problem does not solved, contact
the nearest authorised service agent.
E04
Contact the nearest authorised service agent.
E05
Contact the nearest authorised service agent.
E06
Contact the nearest authorised service agent.
E08
There may be voltage fluctuation in mains.Wait until
voltage is appropriate for working range.
PROBLEM
REASON
SOLUTION
Clothes have shrunk, felted or
deteriorated.
The programme used might not be
suitable for the type of laundry.
Check the care labels on the
laundry items, select a suitable
programme for the type of laundry.
Water leaking from the loading door. There might be lint accumulated on
the inner surfaces of the loading
door and on the surfaces of the
gasket of the loading door.
Clean the inner surfaces of the
loading door and the surfaces of the
gasket of the loading door.
The loading door opens on its own.
The loading door might not be
closed properly.
Push the loading door until you hear
the closing sound.
The water tank warning symbol is
on/flashing.
The water tank might be full.
Empty the water tank.
The water discharge hose might
be bent.
If the product is connected directly
to the water outlet, check the water
discharge hose.
The filter cleaning warning symbol
is on.
The lint filter might be unclean.
Clean the filter.
The filter seat might be clogged
by lint.
Clean the filter seat.
There might be a layer that causes
obstruction on the surface of the
lint filter.
Wash the filter with lukewarm water.
The condenser cleaning warning
symbol is on.
The condenser might be unclean.
Clean the condenser.
The program can not be started and
the filter warning led is blinking
The filter may not be placed
Replace the filter
The filter warning led is blinking
even though the filter is placed
Call technical service
The program can not be started and
filter warning led is blinking
The filter may not be placed
Call technical service
The program can not be started and
condenser warning led is blinking
The condenser may not be placed
Replace the condenser
The program can not be started and
both condenser and filter warning
leds are blinking
The condenser and filter may not
be placed
Replace the filter
The filter and condenser warning
leds are blinking even though the
filter and condenser are placed
Call technical service
