EN - 9
AGENTS SHOULD SUCH A
NEED ARISE.
INSTALLATION
The electrical connection of this hob
should be carried out by an authorized
service technician or a qualified electri
-
cian, according to the instructions in this
guide and in compliance with the cur-
rent regulations.
•
Before connecting your appliance to
the power line at home, make sure to
check the conformity of the voltage
settings, which are specified on the
information check the conformity of
the voltage settings, which are speci-
fied on the information available.
•
The laws, regulations, directives and
standards in force in the country of
use are to be followed (safety regula-
tions, proper recycling in accordance
with the regulations, etc.)
Locating your built-in hob
After removing the packaging material
from the appliance and its accessories,
ensure that the hob is not damaged. If
you suspect any damage, do not use
the appliance and contact an autho-
rised service technician or a qualified
electrician immediately.
This built-in hob is to be inserted into a
cut out of the worktop.
Create an opening with the dimensions
shown in the next picture. The distance
between the rear edge of the hob and
any adjacent wall is dependant on the
wall's surface. Do not use easily com-
bustible material such as: curtains, pa-
per hear the hob.
520mm
590mm
41mm
560mm
490mm
Min.
A
Min.
B
Min.
130mm
Min.
25mm
•
Apply the one-sided self-adhesive se-
aling tape supplied all the way round
the lower edge of the cooking surface
along the outer edge of the glass ce-
ramic panel. Do not stretch it.
•
Screw the 4 worktop mounting brac-
kets on the side walls of the product
Neighbou-
ring walls
A (mm)
B (mm)
Combustible
/
5
0
50
Non-
combustible
worktop mounting
bracket
