EN - 11
Press the timer setting key
to
increase the time or press
to
decrease the time. Adjustment range
is between 0 and 99 minutes. If there
is no operation in 10 seconds, the
minute minder timer will be set and
the blinking dot will disappear. After
the timer is set, the time runs down
according to the adjustment.
When the time is over, a signal sounds
and the timer display blinks. The sound
signal will be stopped automatically
after 30 seconds and/or by operating
any key.
The minute minder timer can be
changed or switched off any time
by operating the increase timer key
and/or decrease timer key
. Switching off the hob by pressing
at any time will also switch off the
minute minder timer.
Cooking zone timer (1 to 99 minutes):
When the hob is switched on, an
independent timer can be programmed
for every cooking zone.
Select a cooking zone, then select the
temperature setting and finally activate
the timer setting
key
, the timer can be programmed
as a switch off function for a cooking
zone. Four LEDs are arranged around
the timer. These indicate for which
cooking zone the timer has been
activated.
10 seconds after the last operation,
the timer display changes to the timer
that will run out next (in the event of
programming more than 1 cooking
zone).
When the timer has run down, a
signal sounds and the timer display
shows "00" statically, the assigned
cooking zone timer LED blinks.
The programmed cooking zone will
be switched off and the "H" will be
displayed if the cooking zone is hot.
The sound signal and the blinking
of the LED timer will be stopped
automatically after 30 seconds and/or
by operating any key.
Buzzer :
While the hob is in operation, the
following activities will be signalled by
means of a buzzer:
Normal key activation with a short
sound signal
Continuous operation of keys over a
longer period of time (10 seconds) with
a longer, intermittent sound signal.
Boost Function:
A cooking zone has to be selected,
cooking level set to the "desired
cooking level" and the P (Boost) key
has to be pressed again.
The Boost-Function can be activated
if the induction module accepts
the setting on this cooking zone. If
the Boost Function is active, a "P"
is displayed on the corresponding
