37
Playback procedure
Place the disc in the
disc slot with the label
side facing forward.
(If the disc has a
label.) Hold the disc
without touching its
surface, align it with
the guides, and place
it in position.
On the screen, “ ” changes to “Reading”
and then playback will commence.
• A menu screen appear on the TV screen, if the
disc has a menu feature. In this case, press
ϳ
/
ϴ
/
ϵ
/
϶
or
ENTER
to operate a menu feature.
Press
STOP
to end playback.
• The unit memorizes the stopped point,
depending on the disc. “ ” appears on the
screen. Press
PLAY
to resume playback (from
the scene point).
• If you press
STOP
again (“
Ϯ
” appears on the
screen) or unload the disc, the TV/DVD will
clear the stopped point.
Press
EJECT
.
Remove the disc and then press
POWER
.
The TV/DVD turns off.
• When you eject the disc, you may hear
mechanism noise, but it is not malfunction.
1
2
3
4
Status display of DVD disc
Press
DISPLAY
. The status display of the disc will
appear on the screen in order like the figure below.
NOTE
• If a non-compatible disc is loaded, “Incorrect Disc”, “Region Code Error” or “Parental Error” will appear on the TV screen
according to the type of loaded disc. If these appear, check your disc again (see pages 5 and 49).
• Some discs may take a minute or so to start playback.
• When an 8 cm disc is placed into the disc slot, and the playback picture or menu display does not appear, press
PLAY
.
• A “Prohibition” symbol “ ” may appear at the upper right of the screen. This symbol means either the feature you tried is
not available on the disc, or the TV/DVD cannot access the feature at this time. This does not indicate a problem with the
TV/DVD.
• When you set a single-faced disc label downwards (i.e. the wrong way up) “Reading” will appear on the display and then
“Incorrect Disc” will be displayed.
• Some playback operations of DVDs may be intentionally fixed by software producers. Since this TV/DVD plays DVDs
according to the disc content recorded, some playback features may not be available. Also refer to the instructions supplied
with the DVDs.
• Do not move the unit during playback. Doing so may damage the disc.
• Use
EJECT
to unload and eject the disc.
• Do not put any objects other than discs on the disc slot. Doing so may cause the unit to malfunction.
• In many instances, a menu screen will appear after playback of a movie is completed. Prolonged display of an on-screen
menu may damage your television set, permanently etching that image onto its screen. To avoid this, be sure to press
POWER
on your remote control once the movie is completed.
• There may be a slight delay between the button is pressed and the function activates.
NOTE
If the TV/DVD does not operate properly:
Static electricity, etc., may affect the player’s operation.
Disconnect the AC power cord once, then connect it again.
Reading
Watching the DVD
CHAPTER
NO.
DVD
00:15:25 01:41:39
Title 1/3
Chapter
2/24
1/1 Eng Dolby Digital
1/2 Eng
1/1
ELAPSED
TIME
ANGLE NO.
DISC OPERATION
TITLE NO.
TOTAL
TIME
AUDIO LANGUAGE
A KIND OF AUDIO
SUBTITLE LANGUAGE
