18
DTV
When the TV accesses to DTV mode for the fi rst time,
you need to run the auto search. To scan all available
services in your area, follow the procedures below.
1
To watch DTV broadcasts, select “DTV” from
auto installation menu. (See page 8.)
2
After setting the channels, you can select a
channel using
CH
a
/
b
or
0 –
9
on the remote
control unit. (See page 5.)
Switching the analogue
audio format
You can switch between multiple audio modes
when watching a multiple audio or stereo broadcast
programme.
In the NICAM TV broadcasts
When receiving a stereo signal
Each time you press
MPX
, the mode switches
between NICAM STEREO and MONO.
Stereo mode
B/G
STEREO
01
BBC1
B/G
MONO
PAL
NICAM
PAL
01
ATV ATV
BBC1
When receiving a bilingual signal
Each time you press
MPX
, the mode switches among
NICAM CH A, NICAM CH B, NICAM CH AB and MONO.
Bilingual mode
B/G
CH A
01
BBC1
B/G
CH B
PAL
NICAM
PAL
NICAM
01
ATV ATV
BBC1
B/G
MONO
01
BBC1
B/G
CH AB
PAL PAL
NICAM
01
ATV ATV
BBC1
When receiving a monaural signal
Each time you press
MPX
, the mode switches
between NICAM MONO and MONO.
Monaural mode
B/G
MONO
01
BBC1
B/G
MONO
PAL
NICAM
PAL
01
ATV ATV
BBC1
ATV (Analogue)/DTV/
RADIO buttons
Use the following buttons on the remote control to
operate the menu.
ATV:
Press to switch to ATV mode. After switching
from DTV, radio or external input mode to ATV
mode, the TV jumps to the most recently viewed ATV
channel.
DTV:
Press to switch to DTV mode. After switching
from ATV, radio or external input mode to DTV
mode, the TV jumps to the most recently viewed DTV
channel.
RADIO:
Press to switch to radio mode. After switching
from DTV, ATV or external input mode to radio mode,
the TV jumps to the most recently tuned radio channel.
When you watch the TV for the fi rst time
When the TV powers on for the fi rst time after
purchase, perform the auto installation.
ATV (Analogue TV)
You can run the auto installation to set channels
automatically.
1
To watch the analogue TV, select “Auto
installation” from Setup menu. (See page 8.)
2
After setting the channels, you can select
a channel using
CH
a
/
b
or
0 –
9
on the
remote control unit. (See page 5.)
LC32L450X_EN.indb 18
LC32L450X_EN.indb 18
05/08/10 02:54:39 PM
05/08/10 02:54:39 PM
