76
LC-42LB261U/LC-50LB261U Sharp 42"/50" LED TV
Remote control
General
No output from
one of the
speakers.
• Adjust the audio balance. See
“
page
• Make sure that the audio cables
are connected correctly and
securely to your TV.
After images
appear.
• Do not display a still image, such
as a logo, game, or computer
image, for an extended period of
time. This can cause a permanent
after-image to be burned into the
screen. This type of damage is not
covered by your warranty.
Problem
Solution
Remote
control does
not work.
• Make sure that the power cord is
correctly connected to your TV and
a power outlet.
• Make sure that there are no
obstructions between the remote
control and the remote control
sensor on the front of the TV.
• Point the remote control directly at
the remote control sensor on your
TV. For the location of the remote
control sensor, see “
page
• The supplied batteries are wrapped
tightly in clear plastic. Make sure
that you have removed this plastic
from the batteries.
• Make sure that the batteries are
installed correctly. See “
page
• Replace dead batteries with new
batteries. See “
” on page
.
Problem
Solution
No power.
• Make sure that the power cord is
correctly connected to your TV
and a power outlet.
• Unplug the power cord, wait 60
seconds, then plug the cord back
in and turn on your TV.
• Other devices (for example, a
surround sound receiver, external
speakers, fans, or hair dryers) may
be interfering with your TV. Try
turning off one device at a time to
determine which device is
causing interference. After you
have determined which device is
causing interference, move it
further from the TV to eliminate
the interference.
Problem
Solution
“No signal”
error message is
displayed.
• Press
INPUT
and make sure that
you have selected the correct
input for the device or service you
are trying to use.
• If you are using a cable or satellite
box, use the remote that came
with that box to change channels.
• Make sure that you have the
correct input selected to view
channels from the cable or
satellite box.
After Auto
Channel Search,
there are no
channels.
• Reception can vary by channel
depending on the broadcast
power level of a given station.
Contact your cable or satellite TV
provider.
• Make sure that the antenna or
cable/satellite TV is connected
securely to your TV.
• Try replacing the cable between
the antenna/cable or
cable/satellite box and your TV.
One or more
channels do not
display.
• Make sure that the channels are
not blocked. See “
” on
page
• Make sure that the channels are
not hidden. The channel may
have been deleted from the
channel list. You can tune to the
channel by pressing the number
buttons or you can add the
channel back to the channel list.
See “
” on
page
• If you are using a cable or satellite
box, use the remote that came
with that box to change channels.
• Make sure that you have the
correct input selected to view
channels from the cable or
satellite box.
• If you are using an antenna, the
digital channel signal may be low.
To check the digital channel
signal strength, see “
” on
page
Password is lost.
• Enter
9999
to access parental
controls, then set a new
password. See “
” on
page
Some settings
cannot be
accessed.
• If a setting is grayed, the setting is
not available in the current video
input mode.
Problem
Solution
