Sharp LC-60UQ10E Operation Manual Download

Page: 16 / 93

Initial auto installation

When the TV is powered on for the first time after
purchase, the initial auto installation wizard appears.
Follow the menus and make the necessary settings
one after another.

Confirm the following before turning on
the power

Is the antenna cable connected?

Is the AC cord plugged in?

Press

on the TV.

• The initial auto installation wizard appears.

Setting the OSD language.

Press

a/b/c/d

to select the desired language, and

then press

;

Selecting the location of the TV.

HOME

STORE

Press

c/d

to select where you will use this TV, and

then press

;

• The confirmation screen pops up only when

selecting “STORE”. Press

c/d

to select “Yes” or

“No”.

• HOME: “STANDARD” will be the default value for

the “AV mode” setting.

• STORE: “DYNAMIC (Fixed)” will be the default

value for the “AV mode” setting. If the “AV mode”
is changed, the TV will automatically switch back
to “DYNAMIC (Fixed)” when there is no operation
using the TV or remote control unit for 30 minutes.

• STORE: A demonstration image will be displayed

after initial auto installation is completed. If you
have chosen “STORE” by mistake, go to “TV
Menu” > “Setup” > “View setting” > “Reset” >
select “HOME” again.

Setting the country.

Press

a/b/c/d

to select your country or area, and

then press

;

• This setting screen only appears during the initial

auto installation.

NOTE

• Some functions may not display or be selectable

depending on the country setting or cable provider
selection.

Setting the PIN.

Press

c/d

to select “Yes”, and then press

;

• When “No” is selected, the PIN code setting is

skipped.

Enter a four-digit number as a PIN using the
0–9 buttons.

Enter the same four-digit number as in step

to confirm.

Press

;

NOTE

• When “France” or “Italy” is selected in the country

setting, the PIN code setting cannot be skipped.

• “0000” cannot be set as the PIN code.
• When the PIN code setting is skipped, the default PIN

code (“1234”) will automatically be set.

• To change the PIN setting, refer to

Individual setting —

PIN

(Page 43). To reset the PIN setting (PIN input will no

longer be needed), refer to

Reset the PIN

(Page 78).

Starting channel search.

Digital search

Analogue search

Satellite search

Press

a/b

to select “Digital search”, “Analogue

search” or “Satellite search”, and then press

;

• After performing “Digital search” or “Analogue

search”, the screen switches to the “Satellite
search” setting. You should then execute “Yes” if
you want to search for satellite channels.

• To watch both digital broadcasts and analogue

broadcasts, you should perform “Digital search” or
“Analogue search” from “Auto installation” under
the “Setup” menu (Page 40).

• When you select “Satellite search”, only satellite

broadcasts will be searched.

• If you want to search for more broadcasts, execute

“Additional search” from the “Programme setup”
menu (Pages 40

42).

NOTE

• If you turn off the power on the TV while performing a

channel search, the initial auto installation wizard will
not appear. The auto installation function allows you
to execute the installation again from “TV Menu” >
“Setup” > “View setting” (Page 40).

• The initial auto installation wizard will abort if you leave

the TV unattended for 30 minutes before searching for
channels.

• When “Italy” or “France” is selected in the country

setting, the default age restriction value is set to 18.

Initial auto installation