– 11 –
MD-MT180
How to reinstall the optical pickup
(See Fig. 11-2.)
1. Remove the screw (E1) x 1 pc., and remove the spring.
2. Slowly raise the optical pickup.
How to remove the Lift motor (See Fig. 11-1.)
1. Remove the solder joints (D1) x 2 of the lift motor lead wire.
2. Remove the screw (D2) x 1 pc., and remove the lift motor.
Note:
Take care so that the motor gear is not damaged.
(If the gear is damaged, noise is caused.)
(D2) x1
ø1.4 x5mm
Lift Motor
SolderJoints
(D1)x2
Spring
Optical Pickup Unit
(E1) x1
ø1.7 x3.5mm
Figure 11-1
Figure 11-2
