MX-3610N MX-RB10/FN10 (PAPER PASS UNIT/FINISHER) 24 – 6
3)
Loosen the fixing screw of the adjustment section on the front
side. If the guide pin is inserted smoothly, tighten the fixing
screws of the adjustment section on the front/rear sides.
By making space between the main body and ground, the
adjustment screw can be turned by the finger.
b. When the guide pin is fit with the connection hole in the
saddle finisher:
1)
Insert the finisher into the main unit. Check to insure that the
upper and lower clearances between the main unit and the
saddle finisher are even.
2)
If the upper and lower clearances between the main unit and
the saddle finisher are not even, and remove the foot cover.
3)
Loosen four fixing screws of the adjustment section, and turn
the height adjustment screws on the front/rear sides to adjust
so that the clearances are even.
By making space between the main body and ground, the
adjustment screw can be turned by the finger.
4)
When the clearances are even, tighten the fixing screw of the
adjustment section, and attach the foot cover.
(5) Main unit and saddle finisher connection
1)
Fix the connection plate to the paper feed desk with fixing
screw B.
2)
Attach the rail bracket to the frame with fixing screw C.
2
1
Clearance
Clearance
1
1
2
2
1
2
1
2
2
1
1
2
