MX-3610N MX-LC11 (LARGE CAPACITY TRAY) 20 – 4
7)
Tighten the loosened screw.
D. Connector connection
1)
Remove the connector cover.
If the dehumidifier heater kit is not installed, there is no need to
remove the connector cover on the lower side.
2)
Connect the connector, and tighten the screw.
If the dehumidifier heater kit is not installed, there is no need to
connect the dehumidifier heater connector to the connector on
the lower side.
E. Paper size switch
Since the factory setting of the paper size is A4, if paper size switch
is required, perform the following procedures.
(1) Paper size switch from A4 to LT
1)
Slowly pull out the tray until it stops.
2)
Loosen the stopper fixing screw on the right lower side of the
tray so that the stopper does not function.
3)
Pull out the tray again until it stops.
1
2
2