3-24 Modem
3
Modem
You can use the modem built in your notebook, for data transfer, fax communication
and voice communication.
Connecting the Modem to Telephone Line
1.
Connect one end of the attached modem cable to the modem jack on the right
side of your notebook.
2.
Connect another end of the cable to the telephone line.
Using Communication Software
To use communication software,
1.
Turn on your notebook.
2.
Press the
F2
key when the message
Press <F2> to enter Setup
appears.
3.
On the
Advanced
page of the Setup Utility, set the
COM1/COM2
Function
to
FAX Modem/IR
or
Serial Port/FAX Modem
.
4.
If you assign the modem to COM1, set the
COM1
Port
to
3F8
,
IRQ4
. If you
assign the modem to COM2, set the
COM2 Port
to
2F8
,
IRQ3
.
5.
On the Power page of the Setup Utility, set
Suspend Mode
to
Suspend to RAM
.
6.
Set
Modem Power when Suspend RAM
to
Enabled
.
7.
Set
Auto Suspend to Disk
to
Disabled
.
8.
Press the
Esc
key and select
Save Changes & Exit
.
9.
In the communication software, set the items such as COM ports, baud rate, etc.
Refer to the software manual or online help or the manual of Windows 95.
(When using commands, refer to
AT Command Reference Manual
.)
The modem is available in the U.S. only.
