Peripherals 4-9
4
Disabling the GlidePoint
When connecting a mouse to your notebook, you can disable the GlidePoint in the
following steps:
1.
Make sure the mouse is enabled before disabling the GlidePoint. If the mouse is
not enabled, the cursor does not move when you move the mouse.
2.
From the
Start
menu, select
SHARP Applications - GlidePoint Control
.
3.
Select
Disables GlidePoint
.
4.
Click
OK
.
If the Glide Point was disabled when entering suspended mode, it will be
enabled after returning from suspended mode
.
Connecting a Serial Mouse
1.
Turn off the notebook.
2.
Locate the RS-232C serial port (
).
3.
Plug the serial mouse into the RS-232C serial port.
Figure 4-4. Connecting a Serial Mouse
4.
Turn on the notebook.
5.
From the
Start
menu, select
Settings
-
Control Panel
.
6.
Double-click
Mouse
.
7.
Click the
General
Tab, then click
Change
.
8.
Select the manufacturer and model name, then click
OK
. Click
Close
.
9.
Click
Yes
and the notebook will restart again.
When the serial mouse is active, the GlidePoint cannot be used.
