CONFIDENTIAL
PN-V601 Installation Guidelines <Rev1.4 > September.30, 2010
CONFIDENTIAL
17
When using remote controller
When using key on the rear pane
Ref.: You can check the PN-V601’s panel status (color, brightness, damage, or existence or nonexistence of
bright point/black point in accordance with the following procedure.
Note that you can’t check all the features of PN-V601 with the following procedure.
Operation checking before installation
Operation check before installation
- Please confirm if each set of the PN-V601 can operate properly prior to the multi-screen positioning.
If trouble is found after the installation, the labor for time detaching is required. In that context,
we strongly recommend the operation check before installation.
- When using interface expansion board, PN-ZB02, confirm its input/output signal.
- Please confirm if the installation tools (e.g. bezel sheet) are set correctly before installation.
1. Press the “SIZE” key (over 5 sec.) and “F” is
displayed at the upper left of screen.
2. Press in turn the keys
3. The screen display changes in following sequence,
with every pressing of the key
Black, Dark blue, Dark green, Dark red,
Blue, Green, Red, White, Gray1, Gray2.
4. Turn off the power after confirming the above.
1. Pres the “MENU” and “INPUT” keys (over 5 sec.)
and “F” is displayed at the upper left of screen
2. Press the [VOL(-)] , [VOL(+)], [VOL(-)], [VOL(+)] key.
3. The screen display changes in following sequence,
with every pressing of the [)] key.
Black, Dark blue, Dark green, Dark red,
Blue, Green, Red, White, Gray1, Gray2.
4. Turn off the power after confirming the above.
Summary of Contents for PN-V601
Page 47: ...46 ...
