Sharp QT-MP3W, Operation Manual

6

QT-MP3W

Preparation for Use

Operation with AC power

Check the setting of the AC voltage selector located on the rear 
panel before plugging the unit into a wall socket. If necessary,
adjust the selector to correspond the AC power voltage used in 
your area.

AC plug adaptor:

In areas (or countries) where a wall socket as shown in illustration 

2

is used, connect the unit using the AC plug adaptor supplied with the
unit, as illustrated. The AC plug adaptor is not included in areas
where the wall socket and AC power plug can be directly connected
(see illustration 

1

).

Notes:

If the unit will not be used for a long period of time, remove the AC
power lead from the wall socket.

Connection of the AC power lead to the unit disconnects the
batteries.

Use only the supplied AC power lead. Using other power leads
may cause an electric shock or fire.

Operation with batteries

Battery replacement:

Replace the batteries when they become weak and/or recording or
playback is impaired. This may occur even though radio broadcasts
are audible.

Notes:

Replace all old batteries with new ones at the same time.

Do not mix old and new batteries.

Remove the batteries if they are weak or if the unit will not be
used for long periods of time. This will prevent potential damage
due to battery leakage.

Batteries are not included.

Caution:

Do not use rechargeable batteries (nickel-cadmium battery, etc.).

To a wall socket

To AC INPUT

AC 110-127/220-240 V,
50/60 Hz

1

2

1

Disconnect the AC power lead, and remove the battery com-
partment cover.

2

Insert 8 "D", size batteries (UM/SUM-1, R20, HP-2 or similar)
into the battery compartment. 

Insert the batteries according to the direction indicated on the
rear panel.

When inserting or removing the batteries, push them towards
the   battery terminals.

Installing the batteries incorrectly may cause the unit to
malfunction.

3

Replace the battery compartment cover.

1

4

3

2

5

6

8

7