E-19
ENGLISH
QT-UH4H
Tape Recording
Enhancing your system
Headphone
Before plugging in or unplugging the headphones, make sure the
volume level is reduced.
Be sure your headphones have a 3.5 mm (1/8") diameter plug and
are between 16 ohms and 50 ohms impedance. The recommend-
ed impedance is 32 ohms.
When headphones are connected, the speakers are disconnected
automatically. Adjust the VOLUME control for desired volume.
Troubleshooting chart
Many potential problems can be resolved by the owner without call-
ing a service technician.
If something is wrong with this product, check the following before
calling your authorised SHARP dealer or service centre.
General
CD player
Tuner
PAUSE
FUNCTION
OFF
ON
• M
IN
MAX
•
MIC
RADIO
TAPE (STAND-BY)
CD/USB
STOP/EJECT F.FWD
REWIND
PLAY
RECORD
OP
EN
BAND
• AM
• FM
KHz
1600
1400
1200
1000
800
700
600
530
AM
MHz
108
106
104
102
100
96
92
90
88
FM
P U
SH
/C
LO
SE
VOLUME
TU
NING
X-BASS
Symptom
Possible cause
When a button is pressed,
the unit does not respond.
Set the unit to the power stand-
by mode and then turn it back on.
No sound is heard.
Is the volume level set to "0"?
Are the headphones connected?
Symptom
Possible cause
Playback does not start.
Is the disc loaded upside down?
Playback stops in the
middle or is not performed
properly.
Does the disc satisfy the
standards?
Is the disc distorted or
scratched?
Playback sounds are
skipped, or stopped in the
middle of a track.
Is the unit located near excessive
vibrations?
Is the disc very dirty?
Has condensation formed inside
the unit?
Symptom
Possible cause
The radio makes unusual
noises continuously.
Is the unit placed near the TV or
computer?
Is the FM aerial placed properly?
Move the aerial away from the
AC power lead if it's located near-
by.