19
R - 2 2 A T
R-23AM
R - 2 4 A T
Pin No.
Signal
I/O
Description
2
IN7
IN
Temperature measurement input: MAGNETRON THERMISTOR AND OVEN
THERMISTOR (2).
By inputting DC voltage corresponding to the temperature detected by the thermis-
tor, this input is converted into temperature by the A/D converter built into the LSI.
3
IN6
IN
Temperature measurement input: OVEN THERMISTOR (1).
By inputting DC voltage corresponding to the temperature detected by the thermis-
tor, this input is converted into temperature by the A/D converter built into the LSI.
4
IN5
IN
A/D input for troubleshooting Magnetron 1.
5
IN4
IN
Terminal to change functions according to the model.
Signal in accordance with the model in operation is applied to set up its function.
6
IN3
IN
A/D input for troubleshooting Magnetron 2.
7
IN2
IN
Connected to GND.(0V)
8
IN1
IN
Terminal not used.
9
IN0
IN
Connected to VC.
10
P47
OUT
Terminal not used.
11
P46
OUT
Memory (EEPROM) clock output.
12
P45
IN/OUT
Memory (EEPROM) data input/output.
13-14
P44-P43
OUT
Magnetron high-voltage circuit driving signal.
To turn on and off the cook relay. In 100% power level operation, "L" level during
cooking; "H" level otherwise. In other power level operation (90, 80, 70, 60, 50, 40,
30, 20, 10 or 0%), "H" and "L" level is repeated according to power level.
Power level
ON
OFF
Power level
ON
OFF
100%
48sec. 0sec.
40%
22sec.
26sec.
90%
44sec. 4sec.
30%
16sec.
32sec.
80%
40sec. 8sec.
20%
12sec.
36sec.
70%
36sec. 12sec.
10%
8sec.
40sec.
60%
32sec. 16sec.
0%
0sec.
48sec.
50%
26sec. 22sec.
15
P42
OUT
Power supply output at thermistor detecting circuit.
(Output -5V in cooking only, but apply high impedance to others to prevent thermistor
from electrolytic corrosion occurrence.)
16
P41
OUT
Terminal not used.
17
P40
OUT
Oven lamp, Blower motor and Stirrer motors driving signal. (Square Waveform
: 50Hz)
To turn on and off the shut-off relay (RY1).
The Square waveform voltage is delivered to
the RY1 relay driving circuit and relays(RY3,
RY4, COOK RELAY) control circuit.
18-22
P37-P33
OUT
Terminal not used.
23
P32
OUT
Signal to sound buzzer.
This signal is to control the 2.5kHz
continuous signal.
A: key touch sound.
B: Guidance sound.
C: Completion sound.
24
P31
IN
Signal synchronized with commercial power source frequency.
This is basic timing for all time processing of LSI.
GND
-5V
48 sec.
OFF
ON
H
L
20 msec
During cooking
H : GND
L (-5V)
20 msec
A
B
C
0.12 sec
2.4 sec
1.2 sec
1.2 sec
GND
-5V
T
200
µ
sec.
200
µ
sec.
