GB-19
CARE AND CLEANING
CAUTION: DO NOT USE COMMERCIAL OVEN
C L E A N E R S , S T E A M C L E A N E R S , A B R A S I V E,
HARSH CLEANERS, ANY THAT CONTAIN SODIUM
HYDROXIDE OR SCOURING PADS ON ANY PART
OF YOUR MICROWAVE OVEN.
CLEAN THE OVEN AT REGULAR INTERVALS AND
REMOVE ANY FOOD DEPOSITS - Keep the oven
clean, or the oven could lead to a deterioration
of the surface. This could adversely affect the
life of the appliance and possibly result in a
hazardous situation.
Oven exterior
The outside of your oven can be cleaned easily with
mild soap and water. Make sure the soap is wiped off
with a moist cloth, and dry the exterior with a soft
towel.
Control panel
Open the door before cleaning to de-activate the
control panel. Care should be taken in cleaning the
control panel. Using a cloth dampened with water
only, gently wipe the panel until it becomes clean.
Avoid using excessive amounts of water. Do not use
any sort of chemical or abrasive cleaner.
Oven Interior
1. For cleaning, wipe any splatters or spills with a
soft damp cloth or sponge after each use while
the oven is still warm. For heavier spills, use a mild
soap and wipe several times with a damp cloth
until all residues are removed. Do not remove the
waveguide cover.
2. Make sure that mild soap or water does not
penetrate the small vents in the walls which may
cause damage to the oven.
3. Do not use spray type cleaners on the oven
interior.
Keep the waveguide cover clean at all times.
The waveguide cover is constructed from a fragile
material and should be cleaned with care (follow the
cleaning instructions above).
NOTE: Excessive soaking may cause disintegration of
the waveguide cover.
The waveguide cover is a consumable part and
without regular cleaning, will need to be replaced.
Turntable and Roller stay
Remove the turntable and roller stay from the oven.
Wash the turntable and roller stay in mild soapy
water. Dry with a soft cloth. Both the turntable and
the roller stay are dishwasher safe.
Door
To remove all trace of dirt, regularly clean both sides of
the door, the door seals and adjacent parts with a soft,
damp cloth. Do not use abrasive cleaner.
NOTE:
A steam cleaner should not be used.
SERVICE CALL CHECK
Please check the following before calling for service.
1. Power Supply
Check the power plug is properly connected to a suitable wall outlet.
Check the line fuse/circuit breaker is functioning properly.
2. Place a cup of water (approx. 150 ml) in the oven and close the door securely.
Programme the oven for one minute on P100 power and start the oven.
Does the oven lamp come on?
YES
NO
Does the turntable rotate?
YES
NO
NOTE:
The turntable turns in either direction.
Does the ventilation work?
(Place your hand over the ventilation openings and check for air flow.)
YES
NO
After 1 minute does the signal sound?
YES
NO
Does cooking in progress indicator go off?
YES
NO
Is the cup with water warm after the above operation?
YES
NO
If you answer “No” to any of the above questions, call a Service Technician appointed by SHARP and report the results
of your check. See inside back cover for details of address.
NOTE:
If you cook the food over the standard time with only P100 (800 W), the power of the oven will lower
automatically to avoid overheating. (The microwave power level will be reduced).
Cooking Mode
Microwave 100 P
Standard time
20 minutes
R-240_OM_01_EN.indd Sek1:19
R-240_OM_01_EN.indd Sek1:19
2011-03-18 21:04:32
2011-03-18 21:04:32
