2 E
2' x 2', 1' x 4' ANd 2' x 4' Recessed Led TRoffeR INsTALLATIoN INsTRUcTIoNs
Intended Use
The Sharp recessed LED troffer is intended for retail,
hospitality, education and other commercial applications.
CaUtIon – safety statements
Warning - Do not handle energized luminaires. Always turn
off power before installing, removing, or inspecting.
Qualified licensed professionals should perform all
installation work. Installation must be completed in strict
conformance with local building and electrical codes.
Do not dis-assemble the luminaire.
Do not remove or attempt to operate without lens cover
over LED.
Warning – Do not expose wiring to edges of metal to
prevent damage.
Warning – For removal of luminaire, turn off power. Allow
luminaire to cool before handling. Reverse process of
installation for removal.
InstallatIon
1. Unpack the product and remove all packing material.
2. Turn off power.
3. Orient luminaire, securely seat in T-bar ceiling grid. See
Figure A.
fIGURe A
fIGU
RE B
4. Remove and retain 2 screws
on the cover plate as shown in
Figure B. Remove knockouts on
the side. Install code approved
fittings to holes for wire
protection.
5. The AC connection will be connected through one
dedicated 1/2 inch conduit entry. Dimmer controls must be
connected through a separate knockout. Use local code
approved twist on wire connectors. See Figure C.
DImmER:
VIOLET, gRAy
gROUnD: gREEn
AC SOURCE:
WhITE, BLACk
fIGURe c
6. Connections shall
follow the wiring
diagram as show in
Figure D.
DImmER
0 - 10V
g
REE
n
W
h
ITE
BLA
C
k
VIOLET
g
RA
y
gROUnD
AC
SOURCE
+ -
fIGURe d
7. Carefully tuck the
wires back into the
enclosure and attach
the cover plate as
shown in Figure E.
fIGURe e
dANGeR - RIsK of sHocK
dIscoNNecT PoWeR BefoRe INsTALLATIoN
