25
SD-AT50W(A)3.fm
02/11/8
SD-AT50W
Advance
d Feature
s
- Time
r a
n
d
s
le
e
p op
e
ra
tion -
To check the timer setting:
Reusing the memorised timer setting:
The timer setting will be memorised once it is entered. To reuse the same setting,
perform the following operations.
Changing the timer setting:
Turn the power on, and repeat the operation from step 1 in "Setting the timer" (page
24).
Cancelling the timer playback:
Timer playback is cancelled by turning the power on whilst in the timer playback
stand-by mode. The same operation can be performed in the following procedure
without turning the power on.
Caution:
"
The contents of the setting will be erased if the system is unplugged or a power
failure occurs. In such cases, set the timer again.
"
This system cannot set the timer of other equipment.
"
When setting the timer playback using other equipment, the connected equipment
should be set to operate the timer playback at the same time.
1
Whilst in the timer playback stand-by mode,
press the TIMER button.
2
Within 10 seconds, press the or button to select "TIMER CALL", and press
the ENTER button.
The system returns to the timer playback stand-by mode after the setting con-
tents are displayed in order.
When the start time is reached:
Playback starts automatically and the volume increases gradually.
The timer play indicator flashes.
Timer play indicator
When the finish time is reached:
The system is set to the power stand-by mode automatically.
1
Turn the power on and press the TIMER button.
Set the AV control unit on time if "TIMER STANDBY" does not appear.
2
Within 10 seconds, press the ENTER button.
After the setting contents are displayed in order, the system is set to the timer play-
back stand-by mode.
1
Press the TIMER button.
"TIMER CANCEL" will appear.
2
Within 10 seconds, press the ENTER button.
Timer playback will be cancelled (the contents of the setting will not be cancelled).
