E-11
SD_HX500_SEC_SECL_E1.fm
04/2/4
ENGLISH
TINSKA015AWZZ
SD-HX500
Pr
epara
tion f
o
r Us
e
- S
yst
em
in
st
alla
ti
o
n
-
System installation
!
Placing the speaker system
The best surround effect will be achieved by placing each speaker at the same
distance from the listening position.
It is recommended to arrange the speakers as shown below.
Notes:
"
Place the TV halfway between the front speakers.
"
It is recommended that the center speaker be placed near the television.
"
Place the surround speakers at a position just above the height of your ears.
"
The subwoofer vibrates while reproducing bass. Place it on a stable, sturdy sur-
face.
"
The subwoofer reproduces bass. Place it anywhere you like.
!
Cooling fan
Caution:
"
The unit will get warm while being used. Do not touch the warm areas of the unit
for prolonged periods to avoid damage to you.
"
This unit contains an automatic protection circuit, which protects the unit from
being damaged. All speaker outputs are muted when this circuit is activated.
Should the unit stop operating, first check the speaker terminals for shorted wires,
then press the ON/STAND-BY button to turn on the unit.
Note:
The default distance is set to 6 feet (2 m). If speakers cannot be placed at equal dis-
tances, refer to "Speaker delay setting" (see page 47).
Installation image:
Front
speaker (left)
Subwoofer
Front
speaker (right)
Surround
speaker (left)
Surround
speaker (right)
Default setting:
6 feet (2 m)
Center
speaker
This unit is fitted with a cooling fan at the rear for improved cooling. Do not cover the
opening in this section with any obstacles.
Cooling fan
Front speaker (left)
Front speaker (right)
Center speaker
