E-25
25-37.fm
01/7/9
SD-SG11
MD Recor
d
ing
Bef
o
re Reco
rd
in
g
t
o
a
Min
iD
isc
Before Recording to a MiniDisc
Disc writing (TOC)
When you start recording or editing, "TOC" will appear on the display.
This indicates that information in the TOC is now being changed according to the
recording or editing being performed. (The changed TOC is not yet recorded on the
MiniDisc at this time.)
The TOC is recorded when
You stop recording.
You switch to another input source.
You eject the MiniDisc.
You set the unit to the stand-by mode.
Do NOT unplug the power cord while the TOC is being recorded ("TOC" is flashing)
and do NOT impart shock to the unit. Otherwise, TOC will not be correctly recorded,
and consequently proper playback may not be possible.
Recordings cannot be made in the following situations.
If you try recording on a playback-only MiniDisc (commercially available music
MiniDisc).
If a MiniDisc is protected against accidental erasure. (See page 44.)
If there is no more recording time left on the disc. (See page 45.)
When the "TOC FULL" message appears. (See page 45.)
If a disc's TOC has been damaged.
Sampling rate converter
This system is equipped with a sampling rate converter, which automatically converts
the sampling frequencies of the connected digital tuners or DAT decks (32 kHz, 48
kHz) to 44.1 kHz. You can digitally record from equipment with different sampling fre-
quencies.
Serial Copy Management System (SCMS)
This player is equipped with a digital copy prevention mechanism which complies
with the SCMS. The SCMS limits the production of digital copies to one generation
for copyright protection. If a digital copy (first generation copy) is made from a copy-
right-protected digital source (audio CD or the like), no further digital copying (from
the second generation) is allowed. The SCMS does not affect analog recording.
Notes for recording
SHARP is not liable for damage or loss of your recording arising from malfunction
of this unit.
When recording important selections, be sure to make a preliminary test to ensure
that the desired material is being properly recorded.
The VOLUME and LOUDNESS controls can be adjusted with no effect to the
recorded signal (Variable Sound Monitor).
About ATRAC
The ATRAC (Adaptive TRansform Acoustic Coding) system compresses the sound
data into 1/5 by cutting out the inaudible sound. Since the sound is selected based on
psychoacoustics masking, the sound quality is not impaired.
This unit is equipped with the ATRAC3 compressing system that can reduce the
sound data to 1/10 or 1/20 of it's original size.
By employing this system, 2 times and 4 times long recording is enabled in stereo
mode.
The TOC (Table of Contents) is information on
track numbers and recording areas to allow the
unit to recognize musical selections or sounds.
The entire MiniDisc is controlled depending on
this TOC, which enables the unit to find the be-
ginning of a track quickly or to automatically
record in a vacant area.
Area for TOC
(recording track
numbers, track
names, etc.)
Area for record-
ing the sound
MiniDisc
(1st generation copy)
Audio CD
MiniDisc
(2nd generation copy)
Digital connection
Analogue connection
Digital recording
"Can't COPY" will appear, and
no recording is allowed.
Impossible
Possible
Downloaded from:
