EN -9-
CHAPTER -3: USING YOUR FRIDGE FREEZER
Adapti-Lift Door Shelf
(In some models)
Six different height adjustments can be made to provide storage
areas that you need by Adapti-Lift.
To change the position of Adapti-Lift ;
Hold the bottom of the shelf and pull the buttons on the side of
the door shelf direction of arrow (Fig.1)
Position door shelf the height you need by moving up and down.
After you get the position that you want the door shelf, release
the buttons on the side of the door shelf (Fig.2) Before releasing
the door shelf, move up down and make sure the door shelf is
fixed
Note:
Before moving door shelf is loaded, you must hold the shelf by supporting the bottom. Otherwise, door shelf
could fall off the rails due to the weight. So damage may occur on the door shelf or rails.
Fig.1
Fig.2
The Fresh Dial
If the crisper is full, the fresh dial located in front of the crisper
should be opened. This allows the air in the crisper and the
humidity rate to be controlled, to increase the life of food
within.
The dial, located behind the shelf, must be opened if any con-
densation is seen on the glass shelf.
Fresh dial
Visual and text descriptions in the accessories section may vary according to the model of your
appliance.
CHAPTER -4: CLEANING AND MAINTENANCE
Disconnect the unit from the power supply before cleaning.
Do not wash your appliance by pouring water on it.
Do not use abrasive products, detergents or soaps for cleaning the appliance. After washing, rinse with clean
water and dry carefully. When you have finished cleaning, reconnect the plug to the mains supply with dry hands.
• Make sure that no water enters the lamp housing and other electrical components.
• The appliance should be cleaned regularly using a solution of bicarbonate of soda and lukewarm water.
• Clean the accessories separately by hand with soap and water. Do not wash accessories in a dish washer.
• Clean the condenser with a brush at least twice a year. This will help you to save on energy costs and increase
productivity.
The power supply must be disconnected during cleaning.
Defrosting
• Your appliance performs automatic defrosting. The water formed as a
result of defrosting passes through the water collection spout, flows into
the vaporisation container behind your appliance and evaporates there.
• Make sure you have disconnected the plug of your appliance before
cleaning the vaporisation container.
• Remove the vaporisation container from its position by removing the
screws as indicated. Clean it with soapy water at specific time intervals.
This will prevent odours from forming.
