EN -9-
CHAPTER -3: USING YOUR FRIDGE FREEZER
Cooler Temperature Settings
• The Initial temperature value for the Cooler Setting indicator is +4°C.
• Press the Cooler Set button once.
• When you first push this button, the last value set appears on the setting indicator of
the cooler.
• Whenever you press on this button a lower temperature will be set. (+8°C, +6°C, +5°C,
+4°C, +2°C, super cool)
• When you push the Cooler Set button until the supercool symbol appears on the Cooler
Setting indicator, and if you do not push any button in 1 seconds the Super Cool symbol
will flash.
• If you continue to press the button, it will restart from +8°C.
• The temperature value selected before Holiday mode, Super Freeze mode, Super Cool
mode or Economy mode is activated will remain the same when the mode is over or
cancelled. The appliance continues to operate with this temperature value.
Recommended settings for your appliance temperature
Freezer partition
Refrigerator
compartment
Remarks
-18 °C
4 °C
For regular use and best performance.
-20 °C, -20 °C or -24 °C
4 °C
Recommended when environmental temperature exceeds 30°C.
SF
4 °C
Must be used when you wish to freeze food in a short period of time.
-18 °C, -20 °C, -20 °C
or -24 °C
2 °C
These temperature settings must be used when the environmental
temperature is high or if you think the refrigerator compartment is not
cool enough because the door is being opened frequently.
-18 °C, -20 °C, -20 °C
or -24 °C
SC
Must be used when the refrigerator compartment is overloaded with
food or when there is food to be cooled instantly.
Warnings About Temperature Adjustments
•
Your temperature adjustments will not be deleted when an energy breakdown occurs.
•
It is not recommended that you operate your fridge in environments colder than 10°C.
•
Temperature adjustments should be made according to the frequency of door openings, the quantity of food
kept inside the fridge and ambient temperature of the placement of your fridge.
•
Your fridge should be operated up to 24 hours according to the ambient temperature without interruption after
being plugged in, this is so it is completely cooled. Do not open the doors of your fridge and do not place food
inside it during this period.
•
A 5 minute delay function is applied to prevent damage to
the compressor of your fridge, when you take the plug out
and then plug it back in again after an energy breakdown
has occurred. Your fridge will start to operate normally after
5 minutes.
•
Your fridge is designed to operate in the ambient
temperature intervals stated in the standards, according
to the climate class stated in the information label. We
do not recommend operating your fridge out of the stated
temperatures value limits in terms of cooling effectiveness.
Note:
If the ambient temperature is higher than 38°C, the compartment temperature cannot be set to -22°C, -23°C or
-24°C. It can only be set to -16°C, -17°C, -18°C, -19°C, -20°C or -21°C.
Climate Class
Ambient Temperature
o
C
T
Between 16 and 43 (°C)
ST
Between 16 and 38 (°C)
N
Between 16 and 32 (°C)
SN
Between 10 and 32 (°C)
Temperature indicator
In order to help you better set your refrigerator, we have equipped it with a temperature indicator located in
the coldest area.
To better store the food in your refrigerator, especially in the coldest area, make sure the message “OK”
appears on the temperature indicator. If « OK » does not appear, this means temperature has not been set
properly
It may be difficult to see the indicator, make sure it is properly lit.Each time the temperature setting device is
changed, wait for the stabilisation of the temperature inside the appliance before proceeding, if necessary,
with a new temperature setting. Please change the position of the temperature setting device progressively and wait at
least 12 hours before starting a new check and potential change.
NOTE:
Following repeated openings (or prolonged opening) of the door or after putting fresh food into the appliance,
it is normal for the indication “OK” not to appear in the temperature setting indicator. If there is an abnormal build up
of ice crystals of ice crystals (bottom wall of the appliance) on the refrigerator compartment, evaporator (overloaded
appliance, high room temperature, frequent door openings), put the temperature setting device on a lower position until
compressor off periods are obtained again.
OK
Summary of Contents for SJ-B1297E0I-EU
Page 2: ......
Page 119: ......
Page 120: ...Waterside Drive Langley Berkshire SL3 6EZ UNITED KINGDOM 52167505 ...
