Sharp SJ-BA05DMXL1-UA, User Manual

EN -7-

CHAPTER -3: USING YOUR FRIDGE FREEZER

Temperature indicator

In order to help you better set your refrigerator, we have equipped it with a temperature indicator located in 

the coldest area.

To better store the food in your refrigerator, especially in the coldest area, make sure the message “OK” 

appears on the temperature indicator. If "OK" does not appear, this means that the temperature setting has 

not been done properly.

Since “OK” appears in black, it will be difficult to see this indication if the temperature indicator is badly lit. To 

be able to see this indication properly, there should be enough light.

Each time the temperature setting device is changed, wait for the stabilisation of the temperature inside the appliance 

before proceeding, if necessary, with a new temperature setting. Please change the position of the temperature setting 

device progressively and wait at least 12 hours before starting a new check and potential change.

NOTE:

 Following repeated openings (or prolonged opening) of the door or after putting fresh food into the appliance, it 

is normal for the indication “OK” not to appear in the temperature setting indicator. If there is an abnormal ice crystals 

build-up (bottom wall of the appliance) on the refrigerator compartment evaporator (overloaded appliance, high room 

temperature,  frequent  door  openings),  set  the  temperature  setting  device  to  a  lower  position  until  compressor  off 

periods are obtained again.

Putting food in the coldest area of the refrigerator

Your foods will be better stored if you put them in the most appropriate 

cooling area. The coldest area is just above the crisper.

The following symbol indicates the coldest area of your refrigerator.

To ensure a low temperature in this area, make sure the shelf is located at 

the the same level as this symbol, as shown in the illustration.

The upper limit of the coldest area is indicated by the lower side of the sticker (head of 

the arrow). The coldest area upper shelf must be at the same level with the arrow head. 

The coldest area is below this level.

As these shelves are removable, make sure they are always at the same level with these 

zone limits described on the stickers, in order to guarantee temperatures in this area.

OK

•  Your fridge is designed to operate in the ambient temperature 

intervals stated in the standards, according to the climate class 

stated in the information label. We do not recommend operating 

your fridge out of the stated temperatures value limits in terms 

of cooling effectiveness.

•  This appliance is designed for use at an ambient temperature 

within the 16°C - 38°C range.

Climate Class Ambient Temperature 

o

C

T

Between 16 and 43  (°C)

ST

Between 16 and 38  (°C)

N

Between 16 and 32  (°C)

SN

Between 10 and 32  (°C)

Important installation instructions

This appliance is designed to work in difficult climate conditions and is powered with ‘Freezer Shield’ technology which 

ensures that the frozen food in the freezer will not defrost even if the ambient temperature falls as low as -15 °C. So 

you may then install your appliance in an unheated room without having to worry about frozen food in the freezer being 

spoilt. When the ambient temperature returns to normal, you may continue using the appliance as usual.

Accessories

Ice tray

•  Fill the ice tray with water and place in freezer compartment.

•  After the water completely turned into ice, you can twist the tray as shown below to get the ice cube.

Freezer box

•  The freezer box is for foods that need to be accessed more easily.

•  Removing The freezer box;

•  Pull the box out as far as possible

•  Pull the front of box up and out.

!

Make the inverse of the same operation for the resetting the sliding 

compartment.

Note:

 Always hold the handle of box while moving in or out.

Freezer boxes