EN -8-
Temperature indicator
In order to help you better set your refrigerator, we have equipped it with a temperature indicator located in the coldest
area.
To better store the food in your refrigerator, especially in the coldest area, make sure the message “OK”
appears on the temperature indicator. If « OK » does not appear, this means temperature has not been set
properly
It may be difficult to see the indicator, make sure it is properly lit.Each time the temperature setting device is
changed, wait for the stabilisation of the temperature inside the appliance before proceeding, if necessary,
with a new temperature setting. Please change the position of the temperature setting device progressively
and wait at least 12 hours before starting a new check and potential change.
NOTE:
Following repeated openings (or prolonged opening) of the door or after putting fresh food into the
appliance, it is normal for the indication “OK” not to appear in the temperature setting indicator. If there is an abnormal
build up of ice crystals of ice crystals (bottom wall of the appliance) on the refrigerator compartment, evaporator
(overloaded appliance, high room temperature, frequent door openings), put the temperature setting device on a lower
position until compressor off periods are obtained again.
Store food in the coldest area of the refrigerator.
Your foods will be better stored if you put them in the most appropriate
cooling area. The coldest area is just above the crisper.
The following symbol indicates the coldest area of your refrigerator.
To be sure to have a low temperature in this area, make sure the shelf is
located at the level of this symbol, as shown in the illustration.
The upper limit of the coldest area is indicated by the lower side of the sticker (head of
the arrow). The coldest area upper shelf must be at the same level with the arrow head.
The coldest area is below this level.
As these shelves are removable, make sure they are always at the same level with these
zone limits described on the stickers, in order to guarantee temperatures in this area.
OK
CHAPTER -3: USING YOUR FRIDGE FREEZER
Accessories
Ice tray
• Fill the ice tray with water and place in freezer compartment.
• After the water completely turned into ice, you can twist the tray as shown below to get the ice cube.
Adapti-Lift Door Shelf
(In some models)
Six different height adjustments can be made to provide storage
areas that you need by Adapti-Lift.
To change the position of Adapti-Lift ;
Hold the bottom of the shelf and pull the buttons on the side of
the door shelf direction of arrow (Fig.1)
Position door shelf the height you need by moving up and down.
After you get the position that you want the door shelf, release
the buttons on the side of the door shelf (Fig.2) Before releasing
the door shelf, move up down and make sure the door shelf is
fixed
Note:
Before moving door shelf is loaded, you must hold the shelf by supporting the bottom. Otherwise, door shelf
could fall off the rails due to the weight. So damage may occur on the door shelf or rails.
Fig.1
Fig.2
Adapti-Shelf
(In some models)
ADAPTI-Shelf mechanism provides higher storage spaces with
a simple movement.
• To cover the glass shelf, push it. (Fig. 1)
• You can place your food as you want in the resulting extra
space. (Fig. 2)
• To bring the shelf to its original position, pull it toward you.
(Fig. 1)
Fig. 1
Fig. 2
