background image

7

PO

LS

K

I

MAGY

AR

ROMÂ

Č

ESKY

SLO

VENSKY

LIETUVI

Ų

 KA

LBA

LATVIAN

EESTI KE

EL

SLOV

ENSKO

CARE AND CLEANING  

Some household cleaning 
chemicals can cause cracks, 
splits or discolouration on the 
inside surface of the refrigerator 
and door liner. 

Only use diluted dishwashing 
liquid

 and ensure that all plastic 

is wiped with fresh water after 
cleaning.

1.

Remove the shelves and pockets from the cabinet and 
door. Wash them in warm soapy dishwashing water; 
rinse in clean water and dry.

2.

Clean the inside with a cloth soaked in warm soapy 
dishwashing water. Then, use cold water to wipe off 
soapy water.

3.

Wipe the exterior with a soft cloth each time it is soiled.

4.

Clean the Magnetic door seal with a toothbrush and 
warm soapy dishwashing water.

5.

Wipe the control panel with the dry cloth.

NOTE:

• 

Do not use hot water, household cleaning powders, 

creams or spray on cleaning products, or any other 
cleaning products such as mineral turpentine, 
methylated spirits, thinners, petrol etc. These may 
damage your refrigerator and may void any warranty.

• 

If undiluted detergent is used or soapy water is not wiped 

off thoroughly, cracking of plastic parts can result.

• 

Wipe any spills from the refrigerator immediately, acid or 

alkaline in the food can cause cracking and staining of 
plastic parts.

• 

The glass shelves weigh approximately 3 kg each. Hold 

firmly when removing from the cabinet or carrying.

• 

Wipe any spills from the control panel immediately, liquid 

ingress can damage the electronics.

Replacing method of the lamp bulb

1. 

Unplug the refrigerator first to prevent electric shock.

2. 

Remove the light cover.

3. 

Replace the lamp bulb with the same type.

CAUTION:

Do not touch the aluminum board around the lamp. 
The edge face of the metal may cause injury.

Switching off your refrigerator

If the refrigerator needs to be switched off for an extended 
period, the following steps should be taken to reduce the 
symptom of mold:

1.

Remove all food.

2.

Remove the power plug from the power point.

3.

Clean and dry the interior thoroughly.

4.

Ensure that all the doors are wedged open slightly for 
air circulation.

WHAT TO DO BEFORE CALLING FOR SERVICE  

If you still require service

 contact your SHARP approved service centre.

Lamp cap E14, MAX 15W, 4 pieces

Light cover

 

Lamp
bulb

Aluminum
board

Problem

Solution

The outside of a cabinet feel hot.

This is due to the compact inbuilt pipes carrying hot gases, the hot pipes also 
prevent dew formation.

When there is refrigerator noise.

Due to the compact design of modern refrigerators, you may hear some 
squeaking, popping, crackling or gurgling sounds from time to time, 
particularly during automatic defrosting. These sounds are quite normal, and 
are generally caused by the compact design, range of operating temperatures 
and the different rates of expansion and contraction of the various materials 
used.

Frosting or dew generation occurs 
inside or outside the refrigerator.

This may occur in one of the following cases. Use a wet cloth for wiping frost 
and a dry cloth for wiping dew.

• 

When the ambient humidity is high.

• 

When the door is frequently opened and closed.

• 

When foods containing plenty of moisture are stored. (Wrapping is required.)

The foods in the refrigerator 
compartment freeze.

• Is the refrigerator operated for a long time with refrigerator temp. control set 

at 0°C?

• Is the refrigerator operated for a long time with freezer temp. control  set at 

-21°C?

• Low ambient temperature may cause placed foods to freeze even if 

refrigerator temp. control  is set to 6°C.

It smells in the compartment.

• Wrapping is required for the foods with strong smell.
• Deodorizing unit cannot remove all of smell.

(A785)̲2.fm  Page 7  Monday, September 3, 2007  3:41 PM

Summary of Contents for SJ-F60PV









Reviews: