7
WARNING
Unplug the refrigerator
fi
rst to prevent electric shock.
■
Do not splash water directly on the outer cabinet or
■
the interior. This may lead to rusting and deterioration
of the electrical insulation.
IMPORTANT
To prevent cracking on inside surfaces and plastic
components, follow these tips.
Wipe any food oils adhered to plastic components.
•
Some household chemicals may cause damage, so use
•
only diluted washing-up liquid (soapy water).
If undiluted detergent is used or soapy water is not wiped
•
off thoroughly, cracking of plastic parts can result.
Wipe any spills from the refrigerator immediately as acid
•
or alkaline in the food can cause cracking and staining of
plastic parts.
1
Remove the accessories e.g. shelves from the cabinet
and door. Wash them in warm soapy dishwashing water;
rinse in clean water and dry.
2
Clean the inside with a cloth soaked in warm soapy
dishwashing water. Then, use cold water to wipe off
soapy water.
3
Wipe the exterior with a soft cloth each time it is soiled.
4
Clean the Magnetic door seal with a toothbrush and
warm soapy dishwashing water.
5
Wipe the control panel with the dry cloth.
NOTE
Do not use hot water, household cleaning powders, creams or
•
spray-on cleaning products, or any other cleaning products such
as mineral turpentine, methylated spirits, thinners, petrol etc.
These may damage your refrigerator and may void any warranty.
If the power supply is disconnected, please wait for at least
•
5 minutes before re-connecting power.
The glass shelves weigh approximately 3 kg each. Hold
fi
rmly
•
when removing from the cabinet or carrying.
Do not drop objects inside the refrigerator or strike the inner
•
wall. This may cause the inner surface to crack.
Replacing method of the lamp bulb
Unplug the refrigerator
fi
rst to prevent electric shock.
1.
Remove the light cover.
2.
Replace the lamp bulb with the same type.
3.
CAUTION
Do not touch the aluminum board around the lamp.
The edge face of the metal may cause injury.
When transporting
Wipe up water in the evaporating pan. Before wiping up
•
the water, wait more than 1 hour after pulling out the plug
because refrigeration cycle equipment is extremely hot.
(The evaporating pan is located on the rear of the product.)
The casters allow the refrigerator to
•
move back and forth.
Carry the refrigerator by holding the handles located on the
•
rear and bottom.
Switching off your refrigerator
If the refrigerator needs to be switched off for an extended
period, the following steps should be taken to reduce the
growth of mould:
Remove all food.
1.
Remove the power plug from the power point.
2.
Clean and dry the interior thoroughly.
3.
Ensure that all the doors are wedged open slightly for air
4.
circulation.
Lamp cap E14, MAX 15W, 4 pieces
CARE AND CLEANING
Casters
Evaporating pan
Light cover
Lamp bulb
Aluminum
board
(B494).indb 7
(B494).indb 7
2013/09/17 10:28:48
2013/09/17 10:28:48
