Sharp SJ-F70PC, Operation Manual

4

INSTALLATION  

1. 

To ensure adequate ventilation for your refrigerator, it is 

recommended to provide space of 6cm on both sides and 
at the back, and space of 9cm above the refrigerator. 
Insufficient spacing will decrease the cooling efficiency, 
resulting in unnecessary consumption of electricity.

2. 

Using the two front Adjustable feet, ensure that the 

refrigerator is positioned firmly and level on the floor.

3. 

When right and left doors are not properly aligned, adjust 
using the adjustable feet.

4. 

Remove the 4 screws of the cabinet lower part, and then 

set the foot cover (supplied inside the refrigerator 
compartment) with removed 4 screws.

5. 

In order to prevent possible electric shock, install the 

grounding wire to the earth wire connecting screw at the 
rear of the refrigerator. (2 pin plug region)

NOTE: 

• 

Position your refrigerator so that the plug is accessible.

• 

Keep your refrigerator out of direct sunlight.

• 

Do not place next to heat generating appliance.

• 

Do not place directly on the ground. 

Provide suitable stand.

• 

To insert the power plug when the door is opened, door 

alarm sounds but it is not abnormal. This sound stops 
when closing the door.

When transporting

• 

Using the casters, it is possible to move back and forth.

• Carry the refrigerator by holding the handles located on 

the rear and bottom.

Before using your refrigerator

Clean the inside parts with a cloth soaked in warm water. 
If soapy water is used, wipe it off thoroughly.

Adjustable foot

Lower the right side.   Lower the left side. 

(Until the adjustable foot on the     

other side is slightly off-ground.)

When the left door is raised.   When the right door is raised.

Foot cover

Screw

Screw

(4 Screws)

Casters

(A704)̲Eng.fm  Page 4  Friday, February 17, 2006  9:55 AM