16
WARNING
Unplug the refrigerator first to prevent electric shock.
■
Do not splash water directly on the outer cabinet or
■
the interior. This may lead to rusting and deterioration
of the electrical insulation.
IMPORTANT
To prevent cracking on inside surfaces and plastic
components, follow these tips.
Wipe any food oils adhered to plastic components.
•
Some household chemicals may cause damage, so use
•
only diluted washing-up liquid (soapy water).
If undiluted detergent is used or soapy water is not wiped
•
off thoroughly, cracking of plastic parts can result.
Wipe any spills from the refrigerator immediately as acid
•
or alkaline in the food can cause cracking and staining of
plastic parts.
1
Remove the water tank and clean and dry it thoroughly
to prevent water stain or bacteria from being attached.
(Once a week)
2
Remove the accessories e.g. shelves from the cabinet
and door. Wash them in warm soapy dishwashing water;
rinse in clean water and dry.
3
Clean the inside with a cloth soaked in warm soapy
dishwashing water. Then, use cold water to wipe off
soapy water.
4
Wipe the exterior with a soft cloth each time it is soiled.
5
Clean the Magnetic door seal with a toothbrush and
warm soapy dishwashing water.
6
Wipe the control panel with the dry cloth.
NOTE
Do not use hot water, household cleaning powders, creams or
•
spray-on cleaning products, or any other cleaning products such
as mineral turpentine, methylated spirits, thinners, petrol etc.
These may damage your refrigerator and may void any warranty.
If the power supply is disconnected, please wait for at least
•
5 minutes before re-connecting power.
The glass shelves weigh approximately 3 kg each. Hold firmly
•
when removing from the cabinet or carrying.
Do not drop objects inside the refrigerator or strike the inner
•
wall. This may cause the inner surface to crack.
Defrosting
Defrosting is fully automatic due to a unique energy saving
system.
When the compartment light is blown
Contact the service agent approved by SHARP to request a
replacement compartment light. The compartment light is not
to be removed other than by qualified service personnel.
When transporting
Before transporting, empty the ice tray by the following
•
procedure.
Empty the water tank and the ice storage box.
1
Set Ice tray cleaning mode “ON”.
2
(Refer to “
Ice tray cleaning
”.)
About 40sec. later, empty water or ice of ice storage
3
box when you hear the ending sound.
Wipe up water in the evaporating pan. Before wiping up
•
the water, wait more than 1 hour after pulling out the plug
because refrigeration cycle equipment is extremely hot.
(The evaporating pan is located on the rear of the product.)
The casters allow the refrigerator to
•
move back and forth.
Carry the refrigerator by holding the handles located on the
•
rear and bottom.
Switching off your refrigerator
If the refrigerator needs to be switched off for an extended
period, the following steps should be taken to reduce the
growth of mould:
Remove all food.
1
.
Remove the power plug from the power point.
2.
Clean and dry the interior thoroughly.
3.
Ensure that all the doors are wedged open slightly for air
4.
circulation.
CARE AND CLEANING
Casters
Evaporating pan
(B351)P2-P19_Eng.indd 16
2012/08/10 17:09:05
Summary of Contents for SJ-FS676V
Page 19: ...19 ...
