Sharp SJ-FS676V, Operation Manual

3

WARNING

Do not install the refrigerator in a damp or wet location 

■

as this may cause damage to the insulation and a 

leakage. Condensation may also build on the outer 

cabinet and cause rust.

1

  Keep adequate ventilation space around the refrigerator.

The figure shows the minimum required space for 

•

installing the refrigerator. The amount of space 

around the refrigerator affects the amount of power 

consumption. 

Insufficient spacing will decrease cooling efficiency 

•

and increase energy consumption. This may reduce 

the life of the unit and void warranty.

2

  Use the two front adjustable feet, to ensure that the 

refrigerator is positioned firmly and flat on the floor.

Before using your refrigerator

Clean the inside parts with a cloth soaked in warm water. 

If soapy water is used, wipe it off thoroughly with water.

INSTALLATION

90mm

or more

60mm

or more

60mm

or more

1180 mm

1500 mm

60mm 

or more

3

  When right and left doors are not properly aligned, adjust 

using the adjustable feet.

NOTE

Position your refrigerator so that the plug is accessible.

•

Keep your refrigerator out of direct sunlight.

•

Do not place next to heat generating appliance.

•

Do not place directly on the ground. Provide suitable stand.

•

If the mains power is switched on when the door is open, the 

•

door alarm will sound. Close the door to stop the alarm.

Adjustable foot

When the left door is 

raised.

When the right door is 

raised.

Lower the foot 

at right side.

Lower the foot 

at left side.

(Until the adjustable foot on the 

other side is slightly off-ground.)

4

  Remove the 4 screws of the cabinet lower part, and 

then set the foot cover (supplied inside the refrigerator 

compartment) with removed 4 screws.

Screw  

(4 screws)

Screw 

Foot cover 

Free standing type

5

  Connect the power plug to a 230/240 volt. 10 amp. 

power point.

(B351)P2-P19_Eng.indd   3

2012/08/10   17:08:35