27
ENGLISH
1
Keep adequate ventilation space around the
refrigerator.
• The picture shows the minimum required space
for installing the refrigerator. The measurement
condition of energy consumption is conducted
under a different space dimension.
90mm
60mm
50mm
1028mm
846mm
• By keeping greater space, the refrigerator may
consume a less amount of power consumption.
• If use the refrigerator in the smaller space
dimension than pictured above, it may cause
temperature rise in the unit, loud noise and failure.
Overall space required in use
SJ-FX800GPW
SJ-FX850TP2
a
1440mm
1432mm
b
1330mm
1330mm
a
b
2
Use the two front the adjustable feet to place the
refrigerator
fl
atly and
fi
rmly on the
fl
oor.
Adjustable foot
3
Use the adjustable feet when right and left doors are
not properly aligned.
When the left door are
raised.
Lower the
foot at right
side.
Lower the
foot at left
side.
When the right door are
raised.
• Turn the adjustable feet until the opposite foot is
slightly off from the ground.
4
Connect the appliance via a correctly installed
socket.
Note
• Place your refrigerator to access the plug.
• Keep your refrigerator out of direct sunlight and do not
place next to heat generating appliance.
• Do not place your refrigerator directly on the ground.
Insert suitable stand such as wooden board under the
refrigerator.
• When you insert the power plug with the door opened,
door alarm sounds but it is normal. This sound stops
after closing the door.
• Do not push the refrigerator against the wall. The wall
surrounding the refrigerator may get dirty or discolored
because of the air
fl
ow caused by heat radiation.
Four casters are located on the bottom of
the refrigerator
• The casters allow the refrigerator to
move back and forth.
Before using your refrigerator
• Clean the inside parts with a cloth soaked in warm
water.
• If you use soapy water to clean, wipe it off thoroughly
with water.
Installation
Free standing type
Casters
02_TINS-B993CBRZ_EN.indd 27
02_TINS-B993CBRZ_EN.indd 27
5/5/2563 BE 16:28
5/5/2563 BE 16:28