Sharp SJ-LC11CTXIF-EN, User Manual

EN -5-

CHAPTER -1: SAFETY INSTRUCTIONS

Installation warnings

Before using your fridge for the first time, please pay attention to the following points:

•  The operating voltage for your fridge is 220-240 V at 50Hz.

•  The plug must be accessible after installation.

•   Before connecting your fridge, ensure that the information on the data plate (voltage and connected load) matches 

that of the mains electricity supply. If in doubt, consult a qualified electrician.

•   Insert the plug into a socket with an efficient ground connection. If the socket has no ground contact or the plug 

does not match, we recommend you consult a qualified electrician for assistance.

•   The appliance must be connected with a properly installed fused socket. The power supply (AC) and voltage at 

the operating point must match with the details on the name plate of the appliance (the name plate is located on 

the inside left of the appliance).

•  We do not accept responsibility for any damages that occur due to improper usage.

•  Place your fridge where it will not be exposed to direct sunlight.

•  Your fridge must never be used outdoors or exposed to rain.

•   Your appliance must be at least 50 cm away from stoves, gas ovens and heater cores, and at least 5 cm away 

from electrical ovens.

•  If your fridge is placed next to a deep freezer, there must be at least 2 cm between them to prevent humidity 

forming on the outer surface.

•  Do not cover the body or top of fridge with lace. This will affect the performance of your fridge.

•   Clearance of at least 150 mm is required at the top of your appliance. Do not place anything on top of your 

appliance.

•  Do not place heavy items on the appliance.

•  Clean the appliance thoroughly before use (see Cleaning and Maintenance).

•   Before  using  your  fridge,  wipe  all  parts  with  a  solution  of  warm  water  and  a  teaspoon  of 

sodium bicarbonate. Then, rinse with clean water and dry. Return all parts to the fridge after 

cleaning.

•   Use the adjustable front legs to make sure your appliance is level and stable. You can adjust 

the legs by turning them in either direction. This must be done before placing food in the 

appliance.

•   Install the two plastic distance guides (the parts on the black vanes -condenser- at the rear) 

by turning it 90° (as shown in the figure) to prevent the condenser from touching the wall.

•  The distance between the appliance and back wall must be a maximum of 75 mm.

Electrical information (For UK type plug)

Warning!

 This appliance must be earthed.

The mains lead of this appliance has been fitted with a specially earthed plug.

Important:

  Do  not  use  the  appliance  without  the  fuse  cover  in 

position. Should the fuse need to be replaced, it must be replaced with a 13A 

fuse, ASTA approved to BS1362.

The plug must be used with a specially earthed socket of 13 amperes. If there 

is  no  such  socket  in  your  house,  please  have  one  installed  by  an  authorised 

electrician.

The mains lead of this appliance has been fitted with a BS 1363A 13A fused plug. 

To change a fuse in this type of plug, follow the steps below:

1. Remove the fuse cover and fuse.

2. Fit replacement 13A fuse, ASTA approved to BS 1362 type, into the fuse 

cover.

3. Replace fuse cover.

During Usage
During Usage

•  Do not connect your fridge to the mains electricity supply using an extension lead.

•  Do not use damaged, torn or old plugs.

•  Do not pull, bend or damage the cord.

•  Do not use plug adapter.

•  This appliance is designed for use by adults. Do not allow children to play with the appliance or hang off the door.

•  Never touch the power cord/plug with wet hands. This may cause a short circuit or electric shock.

•   Do not place explosive or flammable material in your fridge. Place drinks with high alcohol content vertically in the 

fridge compartment and make sure their tops are tightly closed.

When the door of the fridge

 is closed, a vacuum seal will form. Wait for 1 minute before reopening it.

This application is optional for easy opening of the door. With this application, a little condensation may occur around 

this area and you may remove it.