EN -5-
If your refrigerator has a fan condenser:
•
The condenser of your fridge is placed at the bottom
of cabinet. As a result of that, assemble the spacer
by fixing it to holes on the cover bottom panel and
turn 90° that’s shown below figure for arranging the
distance between the refrigera¬tor and the back
wall at where you place the fridge. You can move
the fridge towards the back wall until that point.
•
Refrigerator should be placed against a wall with a
free distance not exceeding 75 mm.
Plastic for distance setting
CHAPTER -1: GENERAL WARNINGS
If your fridge doesn’t have a fan condenser
•
Install using the plastic spacer guides, which can be seen on the condenser at the rear of
the appliance Turn 90 degrees (as shown in the diagram). This will keep the condenser from
touching the wall.
•
Refrigerator should be placed against a wall with a clearance distance not exceeding 75 mm.
Before using your fridge freezer
•
Before setting up your fridge freezer, check for any visible damage. Do not install or use your fridge
freezer if it is damaged
• When using your fridge freezer for the first time, keep it in an upright position for at least 3 hours before
plugging into the mains. This will allow efficient operation and prevent damage to the compressor.
• You may notice a light odour when using your fridge freezer for the first time. This is perfectly normal and
will fade away as the fridge starts to cool.
Information about new-generation cooling technology
Fridge freezers with new-generation cooling technology have a different working system than
static fridge freezers. In normal fridge freezers, humid air entering the freezer and the water
vapour emanating from the foods, turns into frost in the freezer compartment. In order to melt
this frost, in other words defrost, the fridge has to be unplugged. In order to keep foods cold
during the defrosting period, the user must store the food elsewhere and the user must clear the
remaining ice and accumulated frost.
The situation is completely different in freezer compartments equipped with new-generation
cooling technology. With the aid of fan, cold and dry air is blown throughout the freezer
compartment. As a result of the cold air that is blown easily throughout the compartment – even
in the spaces between shelves – foods are frozen equally and properly. And there will be no
frost.
The configuration in the refrigerator compartmentwill be nearly same as the freezer compartment.
Air emitted by the fan located at the top of refrigerator compartment is cooled while passing
through the gap behind the air duct. At the same time, air is blown out through the holes on
the air duct so that cooling process is successfully completed in the refrigerator compartment.
Holes on the air duct are designed for even air distribution throughout the compartment.
Since no air passes between the freezer and refrigerator compartment, odours will not mix.
As a result, your fridge with new-generation cooling technology is easy to use and it offers you
an access to a huge volume and aesthetic appearance.
