16
INSTALLATION
1
Keep adequate ventilation space around the refrigerator.
The figure shows the minimum required space for
•
installing the refrigerator. The measurement condition
of power consumption is conducted under a different
space dimension.
By keeping greater space, the refrigerator may be
•
operated under a less amount of power consumption.
If using the refrigerator in the smaller space dimension
•
than the below figure, it may cause the temperature
rise in the unit, loud noise and failure.
60mm
90mm
1350mm
60mm
60mm
1300mm
Free standing type
2
Use the two front adjustable feet, to ensure that the
refrigerator is positioned firmly and flat on the floor.
3
Clip the foot cover (supplied inside the refrigerator
compartment) in the position on the front of the two
adjustable feet.
NOTE
Position your refrigerator so that the plug is accessible.
•
Keep your refrigerator out of direct sunlight.
•
Do not place next to heat generating appliance.
•
Do not place directly on the ground.
•
Provide suitable stand.
Before using your refrigerator
Clean the inside parts with a cloth soaked in warm water.
If soapy water is used, wipe it off thoroughly with water.
Before transporting
Wipe up water in the evaporating pan.
•
Before wiping up the water, wait more than 1 hour after
pulling out the plug because refrigeration cycle equipment
is extremely hot.
(The evaporating pan is located on the rear of the product.)
NOTE
Do not bend or damage the ductwork located on the inside of
•
the evaporating pan. It may cause failure.
When transporting
The casters allow the refrigerator to move and forth.
•
Carry the refrigerator by holding the handles located on
•
the rear and bottom.
When the door is heavy to open
When one side door is heavy
When the left side is heavy, lower the right side adjustable
•
foot.
(Until the opposite side adjustable foot is slightly off-ground.)
When the right side is heavy, lower the left side adjustable
•
foot.
When both sides are heavy
When the refrigerator is tilted backwards, insert a wooden
•
board (with relatively large width), etc. between the rear of
the refrigerator and the floor to adjust the tilting.
or more
or more
or more
Adjustable foot
Foot cover
A wooden board
(with relatively large
width)
Front
Back
Heavy
Adjustable foot
Casters
(4 pcs.)
rear
bottom
or more
Evaporating pan
WARNING
Do not install the refrigerator in a damp or wet location
■
as this may cause damage to the insulation and a
leakage. Condensation may also build on the outer
cabinet and cause rust.
In order to prevent possible electric shock, connect
■
the receptacle of earth to the earth terminal properly.
(B165).indb 3
2011/02/17 16:55:10
