11
Important
To prevent cracks on the inside surfaces and plastic
components, follow these tips .
•
Wipe out food oil adhered to plastic parts.
• Some household chemicals may cause damage, so use
only diluted washing-up liquid (soapy water).
• If undiluted detergent is used or soapy water is not
wiped off thoroughly, it may result in cracks of plastic
parts.
• Wipe any spills from the refrigerator immediately as acid
or alkaline in the food can cause cracking and staining
of plastic parts.
Cleaning
■
Remove the accessories (e.g. shelves) from the cabinet
and the door. Wash them with warm soapy dishwashing
water. After that, rinse them in clean water and dry.
(Only fruit and vegetable shelf is not removable.)
■
Clean the inside with a cloth soaked in warm soapy
dishwashing water. Then, use cold water to wipe off
soapy water thoroughly.
■
Wipe the exterior with a soft cloth each time it gets
dirty.
■
Clean the Magnetic door seal with a toothbrush and
warm soapy dishwashing water.
■
Wipe the control panel with a dry cloth.
Note
• Do not use hot water, household cleaning powders,
creams or spray-on cleaning products, or any other
cleaning products such as mineral turpentine,
methylated spirits, thinners, petrol etc. These may
damage your refrigerator and may void any warranty.
• If the power supply is disconnected, please wait at least
5 minutes before re-connecting power.
• The glass shelves weigh approximately 3 kg each. Hold
them firmly when removing from the cabinet and carry.
• Do not drop objects inside the refrigerator or strike the
inner wall. This may cause cracks to the inner surface.
Defrosting
Defrosting is automatically operated by a unique energy
saving system.
When the compartment light is blown
Contact the service agent approved by SHARP to replace
the light. The light is not to be replaced other than by
qualified service personnel.
Before transporting
Wipe up water in the evaporating pan. Before wiping
up the water, wait more than 1 hour after pulling out the
power plug because refrigeration cycle equipment is
extremely hot.
(The evaporating pan is located on the rear of the
product.)
Switching off your refrigerator
If the refrigerator needs to be switched off for an extended
period, the following steps should be taken to reduce the
growth of mould:
1.
Remove all food.
2. Remove the power plug from the power point.
3. Clean and dry the interior thoroughly.
4. Ensure that all the doors are wedged open slightly for
air circulation.
Care and cleaning
Evaporating pan
(B658).indb 11
2015/06/16 13:49:45
