5
1
Keep adequate ventilation space around the
refrigerator.
• The picture shows
the minimum required
space for installing
the refrigerator. The
amount of space around
the refrigerator affects
the amount of power
consumption.
• Insufficient spacing will
decrease cooling efficiency and increase energy
consumption. This may reduce the life of the unit
and void warranty.
•
If using the refrigerator in the smaller space
dimension than figured, it may cause temperature
rise in the unit, loud noise and failure.
• The space between the rear of the refrigerator and
the wall should be 60mm or more, and less than
75mm.
If the space is wider than 75mm, you may get
injured by touching compressor and its peripheral
parts which are extremely hot during the operation.
Overall space required in use
Installation
Free standing type
90mm
or more
60mm
or more
60mm
or more
1525 mm
1420 mm
2
Turn the two adjustable feet of the front side to make
the spaces to insert the foot supports.
(The foot supports are packed inside
the refrigerator compartment.)
After inserting the supports,
adjust the two feet to stabilise
the refrigerator.
• The refrigerator is slightly tilted backward by
inserting the supports. It is effective to install the
refrigerator firmly.
3
Remove the 2 screws of the lower part of the cabinet
and use these screws to set the foot cover.
(The foot cover is packed inside the refrigerator
compartment.)
Adjustable foot
Foot support
Ԙ
Ԙ
ԙ
ԙ
Foot cover
Screw
(2 screws)
4
Connect the power plug to a 230/240 volt. 10 amp.
power point.
Note
• Place your refrigerator to access the plug.
• Keep your refrigerator out of direct sunlight and do not
place next to heat generating appliance.
• Do not place your refrigerator directly on the ground.
Insert suitable stand such as wooden board under the
refrigerator.
• When you insert the power plug with the door opened,
door alarm sounds but it is not abnormal. This sound
stops after closing the door.
Before using your refrigerator
Clean the inside parts with a cloth soaked in warm water.
If soapy water is used, wipe it off thoroughly with water.
(B658).indb 5
2015/06/16 13:49:43
