TM150
ADJUSTMENTS, PERFORMANCE CHECK, AND FIRMWARE UPGRADE
2 – 23
CONFIDENTIAL
DRAFT
Comparing with an adjusted handset, click “
b
“ or "
c
" to adjust the value
so that the same gradation pattern is displayed. Click "Save" and
confirm the pattern on the external display.
4-8-16. White defect correction
*
White defect correction:
Defective pixels in a camera light sensor appear as bright points in the
display even when light is blocked completely (display is all black). Per-
form white defect correction to eliminate errors in these pixels.
1.
Protect the handset camera from light completely with a black cover.
2.
Click the "White defect correction" button. The following screen
appears.
Click the "Yes" button and leave it for about 20 seconds.
When completed, the following message appears.
When an error occurs, the corresponding message appears. Solve the
problem according to "Solution".
• Error 1
• Error 2
• Error 3
4-8-17. Black defect correction
*
Black defect correction:
Defective pixels in a camera light sensor appear as black points in the dis-
play even when a captured image is completely white (display is all white).
Perform black defect correction to eliminate errors in these pixels.
1) Requirements
• Desk top type of fluorescent lamp
• Black defect correction sheet
• Illuminance meter
2) Procedure
1. Cover the camera section with the black defect correction sheet as
shown in Figure 96.
2. Check the distance from the fluorescent lamp by using an illumi-
nance meter.
In the proper position for black defect correction, illuminance is
between 8,000 and 10,000 lux.
Error message
: "There are too many white cracks."
Cause
: The light is not sufficiently blocked.
Solution
: Block the light completely and perform white
defect correction again.
Error message
: "There are many white cracks."
Cause
: The light is not sufficiently blocked.
Solution
: Block the light completely and perform white
defect correction again.
Error message
: "There are too many white cracks cannot be
rectified."
Cause
: There is a hardware error.
Solution
: Replace the camera unit.
DEN:
075
8-level gradation pattern (black & white pattern)
TM150
TM150
Attach the Black defect correction sheet
to the handset firmly with clear scotch tape.
Summary of Contents for TM150
Page 61: ...TM150 CIRCUIT DIAGRAM AND PWB LAYOUT 5 13 CONFIDENTIAL DRAFT MAIN PWB_FRONT ...
Page 62: ...TM150 CIRCUIT DIAGRAM AND PWB LAYOUT 5 14 CONFIDENTIAL DRAFT MAIN PWB_REAR ...
Page 63: ...TM150 CIRCUIT DIAGRAM AND PWB LAYOUT 5 15 CONFIDENTIAL DRAFT LCD PWB_FRONT ...
Page 64: ...TM150 CIRCUIT DIAGRAM AND PWB LAYOUT 5 16 CONFIDENTIAL DRAFT LCD PWB_REAR ...
