GB-6
I N ST A LLI N G Y OU R V CR
A U T O I N ST A LLA T I ON
Press
ST OP
to switch on your VCR.
This model will automatically tune in the TV channels in your area, sort them into a standard
order and set the clock.
The screen opposite should be showing on your TV.
Follow the instructions from the screens.
(Auto sort will take a few minutes to complete)
On completion, the MOVE MENU will appear
showing the present channel order. Press
M EN U
to
exit.
If the clock is NOT automatically set, the clock
screen will appear., refer to
M A N U A LLY
SET T I N G T H E CLOCK
. To check the clock has
been set correctly, press DISPLAY until the time
appears on the display.
If you wish to customise the channel order refer to
M A N U A LLY SORT I N G CH A N N ELS
.
V CR RESET
1.
Press
ST OP
to switch on the VCR.
2.
Press and hold
M EN U
and
CH A N N EL
buttons together on the front of the VCR
for 10 seconds.
3.
The AUTO INSTALLATION screen should now be showing on your TV.
4.
Follow the on-screen display to proceed with auto installation.
✔
All the programmes should now be correctly tuned in and the clock set.
Refer to the
CU ST OM I SED I N ST A LLA T I ON
chapter if
•
Your VCR could not tune automatically - due to for example poor reception.
•
You wish to re-arrange the channel order.
•
You wish to change the time on the clock or if the VCR could not set the time.
•
If the screen above does not
appear, follow the procedure
V CR RESET
below.
AU T O
I N S T A L L A T I ON
P R E S S
S E T
K E Y
T O S T AR T
AU T OMA T I S CH E
E I N S T E L L UNG
Z UM B EG I NN , D I E
S E T - T A S T E
DRÜCK E N .
S E T
: E I NGAB E ME NU : E ND E
741 eng.book Page 6 Tuesday, April 27, 1999 11:35 AM
http://www.usersmanualguide.com/
