GB-25
SPECI A L FEA T U RES ON Y OU R V CR
LOW POWER FEA T U RE
To meet new power regulations your VCR can be placed in LOW POWER mode. In LOW
POWER mode the VCR power consumption is reduced to below 2 Watt.
LOW POWER M OD E
1.
Press
ST A N D BY
(
) to place the VCR in STANDBY mode.
2.
Press
ST A N D BY
(
) again to place the VCR in LOW POWER mode. The VCR digital
display will appear blank.
The VCR power consumption will now be below 2 Watt.
D I SEN GA GI N G LOW POWER M OD E
Either
Press
ST A N D BY
(
) to return the VCR to STANDBY mode.
Or
Press
ST OP
(
) to use the VCR.
NOTES:
CH I LD LOCK
You can lock your VCR with this feature. It will work even when the VCR is in standby,
preventing children from operating the VCR.
T O EN GA GE CH I LD LOCK
Press and hold
on the remote control for about 2 seconds.
flashes and then
remains lit on the VCR display confirming that CHILD LOCK
has been activated.
Regardless of what other operating buttons are touched, the VCR will continue to operate in
its present mode. If CHILD LOCK is activated during playback, once the tape reaches its end,
the VCR will automatically rewind the tape, eject it, and turn the power off.
T O D I SEN GA GE CH I LD LOCK
Press and hold
for about 2 seconds.
starts flashing and then disappears. CHILD LOCK is disengaged.
NOTES:
•
With poor signal conditions an increase in noise may be observed on the screen in LOW
POWER mode.
•
When entering STANDBY, noise may be observed.
•
If a signal is input from an AV source, the VCR may not go into true LOW POWER mode.
•
When disengaging low power mode from the VCR press the Standby button.
•
If you attempt to change modes by pressing another button while CHILD LOCK is on,
the
indicator will flash on the VCR display.
•
If power is interrupted for more than 1 hour (due to power failure etc), CHILD LOCK may
disengage.
741 eng.book Page 25 Tuesday, April 27, 1999 11:35 AM
http://www.usersmanualguide.com/
