GB-26
CU ST OM I SED I N ST A LLA T I ON
M A N U A LLY T U N I N G A CH A N N EL
It should not be necessary to tune in a broadcast channel manually except in unusual
circumstances such as poor signal.
To manually tune in a channel follow the procedure below.
1.
Press
M EN U
.
2.
Press [
/
] to select SET UP. Press
SET
to confirm.
3.
CH A N N EL PRESET
will be
highlighted. Press
SET
.
4.
Press [
/
] to select
CH A N N EL
.
5.
Press to select CH or CC. This will
determine whether off air (CH) or cable
(CC) is tuned first. Note that both off air
and cable will be tuned regardless of the
setting.
6.
Press [
/
] to start tuning in either
direction. Tuning will stop when a channel
is received. If it is not the desired channel,
press [
/
] to continue tuning.
7.
Press [
/
] to select
FI N E
T U N I N G
. Press and hold [
/
] until
the sharpest colour picture is obtained.
9.
Press [
/
] to select SKIP.
The SKIP function determines whether the
channel can be selected when using the
CH A N N EL
/
instead of the
N U M BER BU T T ON S
.
10.
Press [
/
] to select ON or OFF for this
option.
11.
Press
SET
to confirm.
12.
Press
M EN U
to leave this function.
I M PORT A N T N OT E:
8.
If you connect an independent
decoder, you must press [
/
] to
select DECODER, then select [
/
] to
turn the decoder function ON.
C H A N N E L
P R E S E T
C H A N N E L S O R T
C L O C K
L A N G U A G E
➔
P R E S E T
1
CHANN E L
CH 2 1
F I N E T UN I NG
▲
▲
D E COD E R
ON
O F F
S K I P
ON
O F F
741 eng.book Page 26 Tuesday, April 27, 1999 11:35 AM
http://www.usersmanualguide.com/
