GB-35
CUSTOMISED INSTALLATION
MANUALLY TUNING A CHANNEL
Normally it will not be necessary to tune in a broadcast channel manually except in unusual
circumstances such as poor signal.
Ensure the video channel is selected on the TV.
1.
Press
MENU
. Press [
/
] to select
SET UP
. Press
SET
to confirm.
2.
CHANNEL PRESET
will be
highlighted. Press
SET
to confirm.
3.
MANUAL TUNING
will be
highlighted. Press
SET
to confirm.
4.
PRESET
will be highlighted. Press
[
/
] to choose the required VCR
preset channel.
5.
If you have SATELLITE CONTROL set to ON
continue from point
6.
Otherwise
continue from point
7
.
6.
Press [
/
] to select
SOURCE
.
Then choose the required source:
•
If you wish to tune a satellite or cable
channel press to [
/
] select
SAT
.
Then press [
/
] to select
CHANNEL
. Enter preset satellite
channel using
NUMBER BUTTONS
or
[
/
] to step through each preset
satellite channel until the channel you
wish is displayed.
Continue from point
10
.
•
If you wish to tune a terrestrial channel
press to [
/
] select CH.
Continue from point
7
.
7.
Press [
/
] to select
CHANNEL
.
8.
Press [
/
] to start tuning in either
direction. Tuning will stop when a channel
is received. If it is not the desired channel,
press [
/
] to continue tuning.
9.
Press [
/
] to select
FINE
TUNING
. Press and hold [
/
] until
the sharpest colour picture is obtained.
IMPORTANT NOTE:
10.
Press [
/
] to select the
DECODER
. This is preset to OFF. If you connect a
satellite receiver into VCR L2, as shown previously, leave decoder OFF. If you connect
a decoder, as shown previously, you must use [
/
] to turn the decoder function
ON. Refer to
DECODER SWITCHING OPERATION
.
S E T U P
C HANN E L
P R E S E T
C HANN E L S O R T
C L O C K
L ANG UAG E
➔
P R E S E T
1
ARD 1
SOURC E CH / CC S A T
CHANN E L
CH 2 1
F I N E T UN I NG
D E COD E R
ON
O F F
S K I P
ON
O F F
▲
▲
Module 15F.fm Page 35 Thursday, September 14, 2000 12:51 PM
